Suppr超能文献

通过扫描电子显微镜评估不同磨刀石对牙周刮治器的影响。

Effect of different sharpening stones on periodontal curettes evaluated by scanning electron microscopy.

作者信息

Huang C C, Tseng C C

机构信息

Dental Department, National Cheng Kung University Medical Center, Tainan, Taiwan, R.O.C.

出版信息

J Formos Med Assoc. 1991 Aug;90(8):782-7.

PMID:1683373
Abstract

The purpose of this study was to evaluate sharpening effect of different sharpening stones on periodontal curettes. In conjunction with 21 brand-new Gracey No. 1/2 curette blades, the Arkansas, India synthetic and ceramic stones were used in this study. The simulated root planing procedure was performed with 45 strokes on freshly extracted, single-rooted teeth. Positive and negative controls were provided. All sharpening procedures were carried out by a clinician and 10 sharpening strokes were applied to each blade with an angle of approximately 70 degrees. The blades were then examined by scanning electron microscopy (SEM). The working edges were investigated within the first 1 to 2 mm from the top of the blade under 500 times of magnification and 3 SEM micrographs were taken from each blade. Micrographs were examined for sharp wire edges, narrow bevel and wide bevel. The Fisher's exact test, Mantel-Haenszel test for trend and 1% probability were used for data analysis. Results indicate that (1) following the simulated root planing procedure, blades became dull, (2) among all the sharpening stones, the ceramic stone was least effective (p less than 0.01) in limited sharpening strokes, (3) with the India synthetic stones, no significant difference was found and they had better sharpening effects than others. This study demonstrates that the sharpening effect of India synthetic stones is the best under SEM examination with a standardized sharpening procedure.

摘要

本研究的目的是评估不同磨刀石对牙周刮治器的磨砺效果。本研究使用了阿肯色石、印度合成石和陶瓷石,与21片全新的Gracey 1/2号刮治器刀片配合使用。在新鲜拔除的单根牙上进行45次模拟根面平整操作。设置了阳性和阴性对照。所有磨砺操作均由一名临床医生进行,以大约70度的角度对每片刀片施加10次磨砺 strokes。然后通过扫描电子显微镜(SEM)检查刀片。在放大500倍的情况下,在距离刀片顶部前1至2毫米范围内检查工作边缘,并从每片刀片上拍摄3张SEM显微照片。检查显微照片上的锋利钢丝边缘、窄斜面和宽斜面。数据分析采用Fisher精确检验、Mantel-Haenszel趋势检验和1%概率检验。结果表明:(1)经过模拟根面平整操作后,刀片变钝;(2)在所有磨刀石中,陶瓷石在有限的磨砺 strokes 中效果最差(p小于0.01);(3)使用印度合成石时,未发现显著差异,且其磨砺效果优于其他磨刀石。本研究表明,在标准化磨砺程序下,经SEM检查,印度合成石的磨砺效果最佳。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验