Okumura Kazu, Yoshino Katsuhiko, Kato Kazuo, Niwa Miki
Department of Materials Science, Faculty of Engineering, Tottori University, Koyama-cho, Tottori 680-8552, Japan.
J Phys Chem B. 2005 Jun 30;109(25):12380-6. doi: 10.1021/jp051021o.
Au/zeolite catalysts prepared with a deposition-precipitation method were characterized with quick XAFS (QXAFS) in combination with IR. The data were correlated with the catalytic performance in the CO-O(2) reaction conducted at 273 K. On the basis of the XANES analysis of Au loaded on H-Y, the deposited Au(2)O(3) was observed at the initial stage. The transformation of Au(2)O(3) to form metal Au clusters was observed at 473 K in a H(2) atmosphere. The fact was supported by the IR measurement of adsorbed CO and the subsequent reaction with O(2). Detailed clustering process of Au supported catalysts could be directly followed by EXAFS analysis. The growth of metal Au proceeded via the formation of a Au(55) cluster at 473 K. Then it agglomerated to give metal Au with diameter of 2 nm at 723 K. The addition of H(2) was effective to retard the sintering of Au clusters. A similar phenomenon was observed over Au loaded on USY zeolite. In marked contrast to the H-Y and USY supports, significantly agglomerated Au particles generated on Na-Y zeolite, indicating the importance of the presence of acid sites in keeping the Au clusters with highly dispersed form. The performance of 5 wt % Au loaded on H-Y and USY in the CO-O(2) reaction was remarkably sensitive to the pretreatment temperature and the gas atmosphere. The catalyst pretreated with hydrogen showed a two-spike pattern with respect to the pretreatment temperature. Namely, the optimum activity was observed after the pretreatment at 373 and 723 K, where the temperatures corresponded to the generation of Au(2)O(3) and metal Au clusters with 2 nm diameter as evidenced by QXAFS analysis, respectively. The reason for enhancement of the activity of Au/H-Y by the addition of H(2) in the pretreatment step could be attributed to the formation of metal Au with appropriate size. In contrast to the H-Y and USY support, Au loaded on Na-Y prepared under the same condition was almost inactive in the reaction due to the formation of aggregated metal Au.
采用沉积沉淀法制备的金/沸石催化剂,通过快速X射线吸收精细结构光谱(QXAFS)结合红外光谱进行表征。将这些数据与在273K下进行的CO - O₂反应中的催化性能相关联。基于对负载在H - Y上的金的X射线吸收近边结构(XANES)分析,在初始阶段观察到沉积的Au₂O₃。在473K的氢气气氛中观察到Au₂O₃向金属金簇的转变。吸附CO的红外测量以及随后与O₂的反应证实了这一事实。通过扩展X射线吸收精细结构(EXAFS)分析可以直接追踪负载金催化剂的详细团聚过程。在473K时,金属金的生长通过形成Au₅₅簇进行。然后在723K时团聚形成直径为2nm的金属金。添加氢气有效地抑制了金簇的烧结。在负载于USY沸石上的金上也观察到类似现象。与H - Y和USY载体形成显著对比的是,在Na - Y沸石上产生了明显团聚的金颗粒,这表明酸性位点的存在对于保持金簇高度分散形式的重要性。负载在H - Y和USY上的5wt%金在CO - O₂反应中的性能对预处理温度和气体气氛非常敏感。用氢气预处理的催化剂相对于预处理温度呈现双峰模式。也就是说,在373K和723K预处理后观察到最佳活性,QXAFS分析表明,这两个温度分别对应于Au₂O₃的生成和直径为2nm的金属金簇的生成。预处理步骤中添加氢气提高Au/H - Y活性的原因可归因于形成了尺寸合适的金属金。与H - Y和USY载体不同,在相同条件下制备的负载在Na - Y上的金由于形成了团聚的金属金,在反应中几乎没有活性。