Mundargi Raghavendra C, Patil Sangamesh A, Agnihotri Sunil A, Aminabhavi Tejraj M
Department of Chemistry, Center of Excellence in Polymer Science, Karnatak University, Dharwad, India.
Drug Dev Ind Pharm. 2007 Mar;33(3):255-64. doi: 10.1080/03639040600897127.
The main focus of this study is to develop colon targeted drug delivery systems for metronidazole (MTZ). Tablets were prepared using various polysaccharides or indigenously developed graft copolymer of methacrylic acid with guar gum (GG) as a carrier. Various polysaccharides such as GG, xanthan gum, pectin, carrageenan, beta-cyclodextrin (CD) or methacrylic acid-g-guar (MAA-g-GG) gum have been selected and evaluated. The prepared tablets were tested in vitro for their suitability as colon-specific drug delivery systems. To further improve the colon specificity, some selected tablet formulations were enteric coated with Eudragit-L 100 to give protection in an acidic environment. Drug release studies were performed in simulated gastric fluid (SGF) for 2 hr followed by simulated intestinal fluid (SIF) at pH 7.4. The dissolution data demonstrate that the rate of drug release is dependent upon the nature and concentration of polysaccharide/polymer used in the formulations. Uncoated tablets containing xanthan gum or mixture of xanthan gum with graft copolymer showed 30-40% drug release during the initial 4-5 hr, whereas for tablets containing GG with the graft copolymer, it was 70%. After enteric coating, the release was drastically reduced to 18-24%. The other polysaccharides were unable to protect drug release under similar conditions. Preparations with xanthan gum as a matrix showed the time-dependent release behavior. Further, in vitro release was performed in the dissolution media with rat caecal contents. Results indicated an enhanced release when compared to formulations studied in dissolution media without rat caecal contents, because of microbial degradation or polymer solubilization. The nature of drug transport was found to be non-Fickian in case of uncoated formulations, whereas for the coated formulations, it was found to be super-Case-II. Statistical analyses of release data indicated that MTZ release is significantly affected by the nature of the polysaccharide used and enteric coating of the tablet. Differential scanning calorimetry indicated the presence of crystalline nature of drug in the formulations.
本研究的主要重点是开发用于甲硝唑(MTZ)的结肠靶向给药系统。使用各种多糖或自主研发的甲基丙烯酸与瓜尔胶(GG)的接枝共聚物作为载体来制备片剂。已选择并评估了各种多糖,如GG、黄原胶、果胶、卡拉胶、β-环糊精(CD)或甲基丙烯酸-g-瓜尔胶(MAA-g-GG)。对制备的片剂进行体外测试,以评估其作为结肠特异性给药系统的适用性。为了进一步提高结肠特异性,一些选定的片剂配方用Eudragit-L 100进行肠溶包衣,以在酸性环境中提供保护。在模拟胃液(SGF)中进行2小时的药物释放研究,然后在pH 7.4的模拟肠液(SIF)中进行。溶出数据表明,药物释放速率取决于制剂中使用的多糖/聚合物的性质和浓度。含有黄原胶或黄原胶与接枝共聚物混合物的未包衣片剂在最初4-5小时内显示30-40%的药物释放,而对于含有GG与接枝共聚物的片剂,这一比例为70%。肠溶包衣后,释放量急剧降至18-24%。在类似条件下,其他多糖无法保护药物释放。以黄原胶为基质的制剂表现出时间依赖性释放行为。此外,在含有大鼠盲肠内容物的溶出介质中进行体外释放。结果表明,与在不含大鼠盲肠内容物的溶出介质中研究的制剂相比,由于微生物降解或聚合物溶解,释放有所增强。未包衣制剂的药物转运性质为非菲克扩散,而包衣制剂的药物转运性质为超Ⅱ型。释放数据的统计分析表明,MTZ释放受到所用多糖的性质和片剂肠溶包衣的显著影响。差示扫描量热法表明制剂中药物存在结晶性质。