Godt R E, Maughan D W
Biophys J. 1977 Aug;19(2):103-16. doi: 10.1016/S0006-3495(77)85573-2.
Frog skeletal muscle fibers, mechanically skinned under water-saturated silicone oil, swell upon transfer to aqueous relaxing medium (60 mM KCl; 3 mM MgCl(2); 3 mM ATP; 4 mM EGTA; 20 mM Tris maleate; pH = 7.0; ionic strength 0.15 M). Their cross-sectional areas, estimated with an elliptical approximation, increase 2.32-fold (+/-0.54 SD). Sarcomere spacing is unaffected by this swelling. Addition of 200 mM sucrose to relaxing medium had no effect on fiber dimensions, whereas decreasing pH to 5.0 caused fibers to shrink nearly to their original (oil) size. Decreasing MgCl(2) to 0.3 mM caused fibers to swell 10%, and increasing MgCl(2) to 9 mM led to an 8% shrinkage. Increasing ionic strength to 0.29 M with KCl caused a 26% increase in cross-sectional area; decreasing ionic strength to 0.09 M had no effect. Swelling pressure was estimated with long-chain polymers, which are probably excluded from the myofilament lattice. Shrinkage in dextran T10 (number average mol wt 6,200) was transient, indicating that this polymer may penetrate into the fibers. Shrinkage in dextran T40 (number average mol wt 28,000), polyvinylpyrrolidone (PVP) K30 (number average mol wt 40,000) and dextran T70 (number average mol wt 40,300) was not transient, indicating exclusion. Maximal calcium-activated tension is decreased by 21% in PVP solutions and by 31% in dextran T40 solutions. Fibers were shrunk to their original size with 8 x 10(-2) g/cm(3) PVP K30, a concentration which, from osmometric data, corresponds to an osmotic pressure (II/RT) of 10.5 mM. As discussed in the text, we consider this our best estimate of the swelling pressure. We find that increasing ionic strength to 0.39 M with KCl decreases swelling pressure slightly, whereas decreasing ionic strength to 0.09 M has no effect. We feel these data are consistent with the idea that swelling arises from the negatively charged nature of the myofilaments, from either mutual filamentary repulsion or a Donnan-osmotic mechanism.
蛙骨骼肌纤维在水饱和硅油中进行机械去皮处理后,转移至水性松弛介质(60 mM氯化钾;3 mM氯化镁;3 mM三磷酸腺苷;4 mM乙二醇双四乙酸;20 mM马来酸三羟甲基氨基甲烷;pH = 7.0;离子强度0.15 M)中会膨胀。用椭圆近似法估算,其横截面积增加2.32倍(±0.54标准差)。肌节间距不受这种膨胀影响。向松弛介质中添加200 mM蔗糖对纤维尺寸无影响,而将pH降至5.0会使纤维几乎收缩至其原始(在油中时)大小。将氯化镁浓度降至0.3 mM会使纤维膨胀10%,而将氯化镁浓度增至9 mM会导致8%的收缩。用氯化钾将离子强度增至0.29 M会使横截面积增加26%;将离子强度降至0.09 M则无影响。用长链聚合物估算膨胀压力,这些聚合物可能被排除在肌丝晶格之外。在葡聚糖T10(数均分子量6200)中的收缩是短暂的,表明这种聚合物可能会渗入纤维。在葡聚糖T40(数均分子量28000)、聚乙烯吡咯烷酮(PVP)K30(数均分子量40000)和葡聚糖T70(数均分子量40300)中的收缩不是短暂的,表明被排除在外。在PVP溶液中,最大钙激活张力降低21%,在葡聚糖T40溶液中降低31%。用8×10⁻² g/cm³的PVP K30可使纤维收缩至其原始大小,根据渗透压数据,该浓度对应的渗透压(II/RT)为10.5 mM。如文中所讨论的,我们认为这是对膨胀压力的最佳估计。我们发现用氯化钾将离子强度增至0.39 M会使膨胀压力略有降低,而将离子强度降至0.09 M则无影响。我们认为这些数据与这样一种观点一致,即膨胀源于肌丝的负电荷性质,源于相互的丝间排斥或唐南渗透机制。