Szczepaniak A, Huang D, Keenan T W, Cramer W A
Department of Biological Sciences, Purdue University, West Lafayette, IN 47907.
EMBO J. 1991 Oct;10(10):2757-64. doi: 10.1002/j.1460-2075.1991.tb07824.x.
Three of the membrane-spanning polypeptides of the chloroplast cytochrome (cyt) b6f complex were sequentially released from the thylakoid membrane, in the order cyt b6, suIV and Rieske iron-sulfur protein, as the pH was increased from 10 to 12, a protocol usually employed to remove peripheral proteins from membranes. The fourth polypeptide of the cyt b6f complex, cyt f, which spans the membrane once, was apparently not released. The pH values for half-release at low ionic strength were approximately 10.7, 11.1 and 11.3 respectively. The separation of the polypeptides of the complex and the sequential release is readily seen at pH 11, where the loss from the membrane of cyt b6, suIV and Fe iron-sulfur center is approximately 90%, 50% and 20%, respectively. the release of cyt b6 from the membrane was reflected by the absence of its characteristic reduced minus oxidized absorbance signal. The pH values at which the release occurred increased as the ionic strength was raised, implying that the release of the b6f polypeptides arises from extrusion due to repulsive electrostatic interactions probably caused by deprotonation of tyrosine and lysine residues. The lipid content of the released polypeptides was very low, consistent with the observation of a non-membranous state. It is proposed that the pH-dependent extrusion requires two electrostatic effects at alkaline pH higher than approximately 10.5: (i) increased electrostatic repulsion between neighbouring polypeptides of the complex, arising from increased net negative charge in the peripheral segments of these polypeptides, which can cause separation of the polypeptides from the complex; and (ii) ionization of residues such as tyrosine in the membrane-spanning alpha-helices, and neutralization of residues such as lysine which can bind to the negative membrane surface.(ABSTRACT TRUNCATED AT 250 WORDS)
随着pH值从10增加到12(这是通常用于从膜上去除外周蛋白的方案),叶绿体细胞色素(cyt)b6f复合物的三个跨膜多肽按细胞色素b6、suIV和 Rieske铁硫蛋白的顺序依次从类囊体膜上释放出来。细胞色素b6f复合物的第四条多肽,即单次跨膜的细胞色素f,显然没有被释放。在低离子强度下,半数释放的pH值分别约为10.7、11.1和11.3。在pH 11时,可以很容易地看到复合物多肽的分离和顺序释放,此时细胞色素b6、suIV和铁铁硫中心从膜上的损失分别约为90%、50%和20%。细胞色素b6从膜上的释放表现为其特征性的还原态减去氧化态吸光度信号消失。随着离子强度的升高,释放发生时的pH值也升高,这意味着b6f多肽的释放是由于酪氨酸和赖氨酸残基去质子化可能导致的排斥性静电相互作用而产生的挤出效应。释放的多肽的脂质含量非常低,这与非膜状态的观察结果一致。有人提出,在高于约10.5的碱性pH下,pH依赖性挤出需要两种静电效应:(i)复合物相邻多肽之间的静电排斥增加,这是由于这些多肽外周段净负电荷增加所致,可导致多肽与复合物分离;(ii)跨膜α螺旋中酪氨酸等残基的电离,以及可与带负电的膜表面结合的赖氨酸等残基的中和。(摘要截短于250字)