Suppr超能文献

雾化富马酸福莫特罗的体外沉积特性:雾化时间、气流、填充体积和雾化器类型的影响

In vitro deposition properties of nebulized formoterol fumarate: effect of nebulization time, airflow, volume of fill and nebulizer type.

作者信息

Okapo Samuel O, Gupta June, Martinez Eloisa, Mark Roach

机构信息

Department of Analytical Development, Dey LP, 2751 Napa Valley Corporate Drive, Napa, CA 4558, USA.

出版信息

Curr Med Res Opin. 2009 Apr;25(4):807-16. doi: 10.1185/03007990802708236.

Abstract

OBJECTIVE

The aim of this study was to investigate in vitro the delivery of a new long-acting beta2-agonist (LABA) drug formoterol fumarate inhalation solution (20 microg/2 mL) nebulized with and without ipratropium bromide (0.5 mg/2.5 mL) at different administration times (2.5-22.5 min), airflows (5-28.3 L/min), nebulizer fill volumes (2-6 mL),and nebulizer brands (Pari LC+, Ventstream and DeVilbiss).

METHOD

Formoterol fumarate with and without ipratropium bromide was aerosolized at different administration times, airflows, nebulizer fill volumes, and nebulizer brands. The drug deposited on the throat, filter and stage plates was collected and analyzed by HPLC to determine the aerodynamic profiles of the nebulized drugs under each variable.

RESULTS

In addition to altering the aerosol characteristics,increasing the nebulizer fill volume including the addition of ipratropium bromide produced a significant(p50.05) increase in the drug output. As expected, sputtering time was significantly longer at low airflows, and vice versa at higher airflows but with a significant loss of drug delivered presumably due to greater solvent evaporation at higher airflows. Airflows between 10 and 28.3 L/min and a nebulization time of approximately 10 min appear sufficient for producing aerosols within the respirable range (1-5 mm MMAD) with the nebulizer/compressor combination used.While the drug output varied significantly (p50.05) among the three brands of nebulizers tested, the LC+ nebulizer appears to produce aerosols (2.7 0.1 microm MMAD) capable of penetrating more deeply into the lung than the other nebulizers evaluated under the current test conditions. This study did not attempt to evaluate different nebulizer/compressor combinations. Also, the cascade impaction data may not necessarily reflect aerosol deposition in the airways in vivo, which may be different depending on the health status of the patient.

CONCLUSION

The results demonstrated that administration of nebulized formoterol fumarate require proper selection of a delivery system/method for safe and effective therapy of the medication with and without ipratropium bromide.

摘要

目的

本研究旨在体外研究一种新型长效β2受体激动剂(LABA)富马酸福莫特罗吸入溶液(20微克/2毫升)在雾化时添加和不添加异丙托溴铵(0.5毫克/2.5毫升),在不同给药时间(2.5 - 22.5分钟)、气流速度(5 - 28.3升/分钟)、雾化器填充体积(2 - 6毫升)以及雾化器品牌(帕里LC +、Ventstream和德维比斯)条件下的情况。

方法

富马酸福莫特罗在添加和不添加异丙托溴铵的情况下,于不同给药时间、气流速度、雾化器填充体积以及雾化器品牌条件下进行雾化。收集沉积在咽喉、过滤器和载物台上的药物,通过高效液相色谱法进行分析,以确定在每个变量下雾化药物的空气动力学特征。

结果

除了改变气溶胶特性外,增加雾化器填充体积(包括添加异丙托溴铵)会使药物输出量显著增加(p<0.05)。正如预期的那样,在低气流速度下溅射时间明显更长,而在高气流速度下则相反,但由于在高气流速度下溶剂蒸发量更大,导致输送的药物有显著损失。对于所使用的雾化器/压缩机组合,10至28.3升/分钟的气流速度和约10分钟的雾化时间似乎足以产生可吸入范围内(1 - 5毫米质量中值空气动力学直径)的气溶胶。虽然在所测试的三个雾化器品牌中药物输出量差异显著(p<0.05),但在当前测试条件下,LC +雾化器似乎产生的气溶胶(质量中值空气动力学直径为(2.7±0.1)微米)比其他评估的雾化器能够更深入地渗透到肺部。本研究未尝试评估不同的雾化器/压缩机组合。此外,多级冲击器数据不一定反映体内气道中的气溶胶沉积情况,这可能因患者的健康状况而异。

结论

结果表明,雾化吸入富马酸福莫特罗时,无论是否添加异丙托溴铵,都需要正确选择给药系统/方法,以实现药物安全有效的治疗。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验