Jabareen Mahmood, Mallik Ajit Sankar, Bilic Grozdana, Zisch Andreas Hugo, Mazza Edoardo
Department of Mechanical and Process Engineering, ETH Zurich, Switzerland.
Eur J Obstet Gynecol Reprod Biol. 2009 May;144 Suppl 1:S134-41. doi: 10.1016/j.ejogrb.2009.02.032. Epub 2009 Mar 17.
We sought to measure the mechanical baseline behavior of fetal membranes in order to determine constitutive mechanical model parameters for fetal membranes, and to examine their relation to molecular correlates for mechanical function, i.e. collagen and elastin.
The uniaxial stress-strain response of nine human term fetal membranes was measured. Methods of nonlinear continuum mechanics were applied for the analysis of the stress-strain curves. Thickness of amnion and chorion were determined from histologic sections for each fetal membrane sample. Complementary biochemical analysis was performed to quantify the soluble collagen and soluble elastin components for each sample.
We report a straightforward histologic modality for measurements of amnion and chorion thickness. Average thickness of the amnion and chorion layers were 111+/-78 microm, and 431+/-113 microm, respectively, which are about twice larger than previously reported. The average content of acid-soluble elastin was 2.1% of wet weight and the one of pepsin/acetic acid-soluble collagen was 10.5% of dry weight. Our data show an inverse proportionality between soluble elastin and soluble collagen content. The low strain elastic modulus ranged between 10 and 25 kPa. Correlations were found between biochemical data and mechanical parameters: there is clearly a direct proportionality between small strain elastic modulus and elastin content. Further, a (less pronounced) direct correlation was observed also between soluble collagen content and the parameter governing the increase in stiffness at larger strains in the nonlinear mechanical model. The mechanical tests revealed a relatively low variability for samples from the same membrane but a large variation between donors. The proposed nonlinear model provides a good fit of the experimental data, with a coefficient of determination, R(2), typically in the range of 0.94. Membranes failure originated at the clamping points thus impairing the quantification of ultimate stress and strain. Thus, no correlation was found between maximum stress and collagen or elastin content.
This study provides a starting point for comprehensive quantitative analysis of the relationship between fetal membranes microstructure and their nonlinear deformation behavior. These insights could become useful in identifying potential medical interventions to prevent membranes rupture.
我们试图测量胎膜的力学基线行为,以确定胎膜的本构力学模型参数,并研究它们与机械功能的分子相关物(即胶原蛋白和弹性蛋白)之间的关系。
测量了九个人类足月胎膜的单轴应力-应变响应。应用非线性连续介质力学方法分析应力-应变曲线。从每个胎膜样本的组织学切片中确定羊膜和绒毛膜的厚度。进行了补充生化分析,以量化每个样本中的可溶性胶原蛋白和可溶性弹性蛋白成分。
我们报告了一种直接的组织学方法来测量羊膜和绒毛膜的厚度。羊膜层和绒毛膜层的平均厚度分别为111±78微米和431±113微米,约为先前报道的两倍。酸溶性弹性蛋白的平均含量为湿重的2.1%,胃蛋白酶/乙酸溶性胶原蛋白的平均含量为干重的10.5%。我们的数据显示可溶性弹性蛋白和可溶性胶原蛋白含量之间呈反比关系。低应变弹性模量在10至25千帕之间。在生化数据和力学参数之间发现了相关性:小应变弹性模量与弹性蛋白含量之间显然存在正比关系。此外,在非线性力学模型中,可溶性胶原蛋白含量与控制较大应变时刚度增加的参数之间也观察到(不太明显的)直接相关性。力学测试表明,来自同一胎膜的样本变异性相对较低,但不同供体之间的差异较大。所提出的非线性模型对实验数据拟合良好,决定系数R²通常在0.94范围内。膜的破坏起源于夹紧点,因此影响了极限应力和应变的量化。因此,未发现最大应力与胶原蛋白或弹性蛋白含量之间存在相关性。
本研究为全面定量分析胎膜微观结构与其非线性变形行为之间的关系提供了一个起点。这些见解可能有助于识别预防胎膜破裂的潜在医学干预措施。