Reynolds Philip A, Gilbert Elliot P, Henderson Mark J, White John W
Research School of Chemistry, The Australian National University, Canberra, ACT 0200, Australia.
J Phys Chem B. 2009 Sep 10;113(36):12231-42. doi: 10.1021/jp903484j.
The small angle neutron scattering from high internal phase water-in-hexadecane and saturated ammonium nitrate-in-hexadecane emulsions is compared with that from related hexadecane-based inverse micellar solutions. Three molecular weights of the monodisperse polyisobutylene acid amide (PIBSA) surfactant 750, 1200, and 1700 were studied over a range of surfactant concentrations. As an additional comparison, emulsions based on sorbitan monooleate and isostearate surfactants were investigated. The scattering from molecular weight 1200 water-based PIBSA emulsions can be fitted at all concentrations to a model with a surfactant coated aqueous droplet-oil interface together with the majority of the surfactant in the oil phase of the emulsion in the form of inverse micelles. Variation of the molecular weight shows a variety of phases of increasing curvature: lamellar, sponge, and, most commonly, the emulsion structure described above. In addition, the molecular weight affects the oil component in the emulsions, which can contain either cylindrical micelles or spherical micelles of varying water but constant hexadecane content. Increased phase curvature is favored by both increased PIBSA molecular weight and ammonium nitrate dissolved in the water. These observations are consistent with "Wedge theory". The structures observed in the emulsions are close to those observed in related inverse micellar solutions made from hexadecane, the surfactant, and water. Lower concentrations of surfactant in the micellar solutions decrease micelle curvature, except where the inverse micelles are spherical and small; here, there is little effect of dilution. Substitution of sorbitan surfactants for PIBSAs produces slightly less organized but similar structures, with smaller spherical micelles containing proportionally more water. The aqueous-oil droplet interface has a relatively invariant monolayer of adsorbed surfactant. For all emulsions, we can infer from the mass balance that micelle concentrations are depressed in the inverse micellar solutions because up to half the added surfactant is present as individually dissolved molecules.
将十六烷中高内相水包油乳液和饱和硝酸铵十六烷乳液的小角中子散射与相关的基于十六烷的反胶束溶液的小角中子散射进行了比较。研究了单分散聚异丁烯酰胺(PIBSA)表面活性剂三种分子量(750、1200和1700)在一系列表面活性剂浓度下的情况。作为额外的比较,还研究了基于脱水山梨醇单油酸酯和异硬脂酸酯表面活性剂的乳液。分子量为1200的水基PIBSA乳液在所有浓度下的散射都可以用一个模型来拟合,该模型中,水相液滴 - 油界面被表面活性剂包覆,并且乳液油相中大部分表面活性剂以反胶束的形式存在。分子量的变化显示出曲率增加的各种相:层状、海绵状,最常见的是上述乳液结构。此外,分子量会影响乳液中的油成分,乳液中的油成分可以包含不同含水量但十六烷含量恒定的圆柱形胶束或球形胶束。PIBSA分子量的增加和溶解在水中的硝酸铵都有利于相曲率的增加。这些观察结果与“楔理论”一致。乳液中观察到的结构与由十六烷、表面活性剂和水制成的相关反胶束溶液中观察到的结构相近。胶束溶液中较低的表面活性剂浓度会降低胶束曲率,但反胶束为球形且较小时除外;在此情况下,稀释的影响很小。用脱水山梨醇表面活性剂替代PIBSA会产生组织性稍差但相似的结构,其中较小的球形胶束含有比例更高的水。水 - 油液滴界面有一层相对不变的吸附表面活性剂单分子层。对于所有乳液,我们可以从质量平衡推断出,反胶束溶液中的胶束浓度会降低,因为添加的表面活性剂中多达一半以单独溶解的分子形式存在。