Onibokun Adebukola, Khoo Larry T, Bistazzoni Simona, Chen Nan Fu, Sassi Marco
Division of Neurosurgery, UCLA Medical Center, Los Angeles, CA 90095, USA.
Spine J. 2009 Sep;9(9):729-34. doi: 10.1016/j.spinee.2009.04.021.
BACKGROUND CONTEXT: Successful placement of pedicle screws in the cervical spine requires a sufficient three-dimensional understanding of pedicle morphology to allow accurate identification of the screw axis. PURPOSE: The goal of the present study was to assess morphologic trends from one level to the next with respect to linear and angular parameters associated with the subaxial cervical pedicles. STUDY DESIGN/SETTING: We evaluated the pedicle morphology of cervical spine using axial and sagittal computed tomography (CT) imaging. The C3-C7 vertebrae in 122 patients (610 vertebrae) were evaluated (age range, 14-93; mean, 48 years). METHODS: Thin cut (2.5mm thickness) axial CT images were measured. Sagittal reconstructions were obtained using 1.25-mm thickness slices. The following pedicle parameters were assessed: pedicle width (PW, the mediolateral diameter of the pedicle isthmus, perpendicular to the pedicle axis), pedicle height (PH, rostro-caudal dimension of the pedicle determined on the sagittal image), maximal screw length (MSL, distance from the posterior cortex of the lateral mass to the anterior wall of the vertebral body along the pedicle axis), and pedicle transverse angle (PTA, angle between the pedicle axis and the midline vertebral body). RESULTS: The overall mean PW and PH ranged from 4.7 to 6.5mm and 6.4 to 7.0mm, respectively. For both these parameters there was a trend toward increasing size proceeding caudally in the cervical spine. The mean PW and PH was greater in males than in females, and this difference was statistically significant at all levels (p<.0001). The overall mean MSL ranged from 29.9 to 32.9 mm. All intersections of the pedicle axis and the posterior cortex of the lateral mass were located at the most lateral portion of the lateral mass for the C3-C6 vertebrae. The overall mean PTA ranged from 37.8 degrees to 45.3 degrees . The overall mean PTA was approximately 44 degrees from C3 to C6 and 37.8 degrees at C7. CONCLUSION: The findings of our radiological anatomical study suggest that the preoperative CT scans of patients undergoing cervical transpedicular fixation should be thoroughly analyzed and close attention paid to the pedicle size and its angulation. The placement of cervical pedicle screws should be individualized for each patient and based on detailed preoperative planning.
背景:在颈椎中成功置入椎弓根螺钉需要对椎弓根形态有充分的三维理解,以便准确确定螺钉轴线。 目的:本研究的目的是评估下颈椎椎弓根相关线性和角度参数从一个节段到下一个节段的形态学趋势。 研究设计/地点:我们使用轴向和矢状面计算机断层扫描(CT)成像评估颈椎的椎弓根形态。对122例患者(610个椎体)的C3 - C7椎体进行了评估(年龄范围14 - 93岁;平均48岁)。 方法:测量薄层(2.5mm厚)轴向CT图像。使用1.25mm厚的切片获得矢状面重建图像。评估以下椎弓根参数:椎弓根宽度(PW,椎弓根峡部的内外侧直径,垂直于椎弓根轴线)、椎弓根高度(PH,在矢状面上确定的椎弓根的头尾向尺寸)、最大螺钉长度(MSL,沿椎弓根轴线从侧块后皮质到椎体前壁的距离)和椎弓根横向角度(PTA,椎弓根轴线与椎体中线之间的角度)。 结果:总体平均PW和PH分别为4.7至6.5mm和6.4至7.0mm。对于这两个参数,颈椎中从尾端向头端有增大的趋势。男性的平均PW和PH大于女性,且在所有节段这种差异均具有统计学意义(p <.0001)。总体平均MSL为29.9至32.9mm。对于C3 - C6椎体,椎弓根轴线与侧块后皮质的所有交点均位于侧块的最外侧部分。总体平均PTA为37.8度至45.3度。从C3到C6总体平均PTA约为44度,在C7为37.8度。 结论:我们的放射解剖学研究结果表明,对于接受颈椎经椎弓根固定的患者,术前CT扫描应进行全面分析,并密切关注椎弓根大小及其角度。颈椎椎弓根螺钉的置入应针对每个患者进行个体化,并基于详细的术前规划。
Spine (Phila Pa 1976). 2000-7-1
Acta Neurochir (Wien). 2018-4
Spine (Phila Pa 1976). 2006-5-1
Spine (Phila Pa 1976). 2004-11-15
Spine Surg Relat Res. 2024-12-20
Surg Neurol Int. 2024-8-23
J Orthop Surg Res. 2024-8-8
Medicine (Baltimore). 2024-3-15
Turk J Med Sci. 2022-8