Division of Infectious Diseases, UT Southwestern Medical Center, 5323 Harry Hines Blvd., Dallas, TX 75390-9113, USA.
Antimicrob Agents Chemother. 2010 Apr;54(4):1484-91. doi: 10.1128/AAC.01474-09. Epub 2010 Jan 19.
Arguably, one of the most common and consequential laboratory tests performed in the world is Mycobacterium tuberculosis susceptibility testing. M. tuberculosis resistance is defined by growth of > or =1% of a bacillary inoculum on the critical concentration of an antibiotic. The critical concentration was chosen based on inhibition of > or =95% of wild-type isolates. The critical concentration of isoniazid is either 0.2 or 1.0 mg/liter, that of rifampin is 1.0 mg/liter, that of pyrazinamide is 100 mg/liter, that of ethambutol is 5.0 mg/liter, and that of fluoroquinolones is 1.0 mg/liter. However, the relevance of these concentrations to microbiologic and clinical outcomes is unclear. Critical concentrations were identified using the ability to achieve the antibiotic area under the concentration-time curve/MIC ratio associated with > or =90% of maximal kill (EC(90)) of M. tuberculosis in > or =90% of patients. Population pharmacokinetic parameters and their variability encountered in tuberculosis patients were utilized in Monte Carlo simulations to determine the probability that particular daily doses of the drugs would achieve or exceed the EC(90) in the epithelial lining fluid of 10,000 tuberculosis patients. Failure to achieve EC(90) in > or =90% of patients at a particular MIC was defined as drug resistance. The critical concentrations of moxifloxacin and ethambutol remained unchanged, but a critical concentration of 50 mg/liter was identified for pyrazinamide, 0.0312 mg/liter and 0.125 mg/liter were defined for low- and high-level isoniazid resistance, respectively, and 0.0625 mg/liter was defined for rifampin. Thus, current critical concentrations of first-line antituberculosis drugs are overoptimistic and should be set lower. With the proposed breakpoints, the rates of multidrug-resistant tuberculosis could become 4-fold higher than currently assumed.
可以说,全世界最常见和最重要的实验室检测之一是结核分枝杆菌药敏试验。结核分枝杆菌耐药性的定义是,在抗生素的临界浓度下,细菌接种物的生长率≥1%。临界浓度是根据对野生型分离株的抑制率≥95%来选择的。异烟肼的临界浓度为 0.2 或 1.0 毫克/升,利福平为 1.0 毫克/升,吡嗪酰胺为 100 毫克/升,乙胺丁醇为 5.0 毫克/升,氟喹诺酮类药物为 1.0 毫克/升。然而,这些浓度与微生物学和临床结果的相关性尚不清楚。临界浓度是通过达到与结核分枝杆菌>90%的最大杀灭率(EC90)相关的抗生素浓度-时间曲线/最小抑菌浓度(MIC)比值的能力来确定的,这在>90%的患者中是可以实现的。利用结核患者的群体药代动力学参数及其变异性进行蒙特卡罗模拟,以确定特定药物日剂量在 10000 名结核患者的上皮衬液中达到或超过 EC90 的概率。在特定 MIC 下,未能使>90%的患者达到 EC90 被定义为药物耐药性。莫西沙星和乙胺丁醇的临界浓度保持不变,但吡嗪酰胺的临界浓度为 50 毫克/升,低水平和高水平异烟肼耐药性的临界浓度分别为 0.0312 毫克/升和 0.125 毫克/升,利福平的临界浓度为 0.0625 毫克/升。因此,目前一线抗结核药物的临界浓度过于乐观,应该降低。采用新的折点,耐多药结核病的发生率可能比目前假设的高出 4 倍。