Department of Anatomy, Sri Aurobindo Institute of Medical Sciences, Indore, Madhya Pradesh, India.
Neurosurg Focus. 2010 Mar;28(3):E12. doi: 10.3171/2009.12.FOCUS09265.
Although the area at the auricular surface defines the magnitude of weight transmission to the hip bones, this study proposes that the position of the auricular surfaces may also significantly influence load bearing patterns at the sacrum. This study attempts to investigate and classify variable positions of the auricular surfaces that may cause vertical shifts in weight-bearing patterns between the L-5 and S-1 segments, altering weight distribution at the lumbosacral and sacroiliac regions.
Three hundred human sacra were studied to determine the position and extent of their auricular surfaces in relation to the sacral segments. Specimens were grouped as "normal," "high-up," and "low-down" auricular surface-bearing sacra. All bones were also scrutinized for the presence of accessory articulating facets on the ala of the sacrum and sacralization of the L-5 segment or lumbarization of the S-1 segment. Seven dimensions and 5 articular areas were measured in all sacra. Nine indices were calculated to show proportional representation of dimensions and areas in the bones. Obtained data were analyzed for differences in groups of sacra bearing different auricular surface positions.
Thirty-nine of the sacra (13%) showed auricular surfaces that occupied a high-up position (from upper S-1 to low S-2 segments). Forty-four of the sacra (15%) exhibited a low-down auricular surface (from the low S-1 to low S-3 sacral segments). The remaining bones demonstrated a normal position of the surface (from the S-1 to the middle of the S-3 segments). Twenty of the high-up sacra demonstrated unilateral or bilateral accessory articulating facets on the alae that articulated with extended transverse processes of the L-5 vertebrae. The low-down sacra transmitted load predominantly via lower (S2-3) segments and exhibited stouter, broader, and efficient weight-bearing lower sacral elements, and a prominent gap between the S-1 segment and the rest of the sacrum. The high-up sacra: 1) were shorter and broader in comparison with the normal sacra; 2) at times presented accessory articular facets on their alae; 3) had a smaller body span and a wider ala; 4) were found to have the plane of the facet joints nearer to the posterior aspect of the S-1 body; and 5) had the smallest of the facet areas. The low-down sacra were longer than they were broad, had a substantially broad body span at S-1, possessed the smallest interauricular distance, and showed considerable depth of the plane of the facet joints.
The position of the auricular surface varies in human sacra. These variations are associated with differential load bearing at the sacral joints. Only the high-up sacra demonstrated the presence of accessory articulating facets between L-5 and S-1. The position of the auricular surface can explain or possibly predict low-back pain situations.
尽管耳状面的面积决定了髋关节的负重程度,但本研究提出,耳状面的位置也可能显著影响骶骨的承重模式。本研究试图调查和分类耳状面的可变位置,这些位置可能导致 L-5 和 S-1 节段之间的负重模式发生垂直转移,从而改变腰骶部和骶髂部的体重分布。
研究了 300 个人的骶骨,以确定其耳状面在骶骨节段中的位置和范围。标本分为“正常”、“高位”和“低位”耳状面承载骶骨。还对所有骨骼进行了检查,以确定骶骨翼上是否存在附加关节面以及 L-5 节段的骶骨化或 S-1 节段的腰椎化。在所有骶骨中测量了 7 个维度和 5 个关节区域。计算了 9 个指数,以显示骨骼中各维度和区域的比例代表。对承载不同耳状面位置的骶骨组进行了差异分析。
39 个骶骨(13%)的耳状面呈高位(从 S-1 上段至 S-2 下段)。44 个骶骨(15%)表现为低位耳状面(从 S-1 下段至 S-3 下段)。其余骨骼表现为正常的耳状面位置(从 S-1 至 S-3 中段)。20 个高位骶骨的骶骨翼上有单侧或双侧与 L-5 椎体延伸的横突相接的附加关节面。低位骶骨主要通过下部(S2-3)节段传递负荷,并表现出更粗壮、更宽、更有效的下部骶骨承重元素,以及 S-1 节段与骶骨其余部分之间的明显间隙。高位骶骨:1)与正常骶骨相比更短更宽;2)有时在其骶骨翼上有附加关节面;3)体宽较小,骶骨翼较宽;4)关节面关节的平面更靠近 S-1 体的后侧面;5)关节面面积最小。低位骶骨较长而较宽,S-1 处的体宽明显较宽,耳状面间距最小,关节面的平面深度较大。
耳状面在人类骶骨中的位置存在差异。这些变化与骶骨关节的不同承重有关。只有高位骶骨显示 L-5 和 S-1 之间存在附加的关节面。耳状面的位置可以解释或可能预测下腰痛的情况。