Dpto. Química Analítica, Facultad de CC. Químicas, Universidad Complutense de Madrid, Madrid, Spain.
Talanta. 2010 May 15;81(3):925-33. doi: 10.1016/j.talanta.2010.01.038. Epub 2010 Jan 25.
Integrated amperometric biosensors for the determination of L-malic and L-lactic acids were developed by coimmobilization of the enzymes L-malate dehydrogenase (MDH) and diaphorase (DP), or L-lactate oxidase (LOX) and horseradish peroxidase (HRP), respectively, together with the redox mediator tetrathiafulvalene (TTF), on a 3-mercaptopropionic acid (MPA) self-assembled monolayer (SAM)-modified gold electrode by using a dialysis membrane. The electrochemical oxidation of TTF at +100mV (vs. Ag/AgCl), and the reduction of TTF(+) at -50mV were used for the monitoring of the enzyme reactions involved in L-malic and L-lactic acid determinations, respectively. Experimental variables concerning the biosensors composition and the detection conditions were optimized for each biosensor. Good relative standard deviation values were obtained in both cases for the measurements carried out with the same biosensor, with no need of cleaning or pretreatment of the bioelectrodes surface, and with different biosensors constructed in the same manner. After 7 days of continuous use, the MDH/DP biosensor still exhibited 90% of the original sensitivity, while the LOX/HRP biosensor yielded a 91% of the original response after 5 days. Calibration graphs for L-malic and L-lactic were obtained with linear ranges of 5.2x10(-7) to 2.0x10(-5) and 4.2x10(-7) to 2.0x10(-5)M, respectively. The calculated detection limits were 5.2x10(-7) and 4.2x10(-7)M, respectively. The biosensors exhibited a high selectivity with no significant interferences. They were applied to monitor malolactic fermentation (MLF) induced by inoculation of Lactobacillus plantarum CECT 748(T) into a synthetic wine. Samples collected during MLF were assayed for L-malic and L-lactic acids, and the results obtained with the biosensors exhibited a very good correlation when plotted against those obtained by using commercial enzymatic kits.
用于测定 L-苹果酸和 L-乳酸的集成安培生物传感器通过将酶 L-苹果酸脱氢酶 (MDH) 和二氢蝶呤 (DP) 或 L-乳酸氧化酶 (LOX) 和辣根过氧化物酶 (HRP) 分别与氧化还原介体四硫富瓦烯 (TTF) 共固定化在 3-巯基丙酸 (MPA) 自组装单层 (SAM) 修饰的金电极上,通过使用透析膜来制备。在 +100mV(相对于 Ag/AgCl)处电化学氧化 TTF,并在 -50mV 处还原 TTF(+),分别用于监测涉及 L-苹果酸和 L-乳酸测定的酶反应。优化了每种生物传感器的组成和检测条件的实验变量。使用相同的生物传感器进行测量时,两种情况下均获得了良好的相对标准偏差值,而无需清洁或预处理生物电极表面,并且以相同的方式构建了不同的生物传感器。在连续使用 7 天后,MDH/DP 生物传感器仍保持原始灵敏度的 90%,而 LOX/HRP 生物传感器在 5 天后仍保持原始响应的 91%。获得了 L-苹果酸和 L-乳酸的校准曲线,线性范围分别为 5.2x10(-7) 至 2.0x10(-5) 和 4.2x10(-7) 至 2.0x10(-5)M。计算出的检测限分别为 5.2x10(-7) 和 4.2x10(-7)M。生物传感器具有高选择性,没有明显的干扰。它们被应用于监测接种植物乳杆菌 CECT 748(T) 引起的苹果酸-乳酸发酵 (MLF)。在 MLF 过程中收集的样品用于测定 L-苹果酸和 L-乳酸,并且与使用商业酶试剂盒获得的结果相比,生物传感器获得的结果相关性非常好。