Centre for Energy Study, Indian Institute of Technology Delhi, New Delhi, India.
J Environ Sci Health A Tox Hazard Subst Environ Eng. 2010 Aug;45(10):1256-63. doi: 10.1080/10934529.2010.493812.
In the present study, an attempt was made for the removal of Remazol Black B dye (azo dye) by using Aspergillus Flavus during its growth. Biosorption of the azo dye by growing fungi was investigated in batch reactors as a function of initial concentration of dye (25-1000 mg/L), inoculum concentration (5-20%), and pH (2.5-6.5). The total biomass concentration decreased from 6.3 g/L to 1.44 g/L by increasing the dye concentration from 0 to 1000 mg/L. The dye uptake increased from 4.37 to 233 mg/g of dried biomass by increasing initial concentration of dye from 25 to 1000 mg/L. The nearly complete removal of dye was found at initial concentration upto 250 mg/L and at pH 4.5 which was used as working pH value for removal of dye in all the batch studies. The removal of Chemical Oxygen Demand (COD) was found to be 90% at 100 mg/L initial concentration of dye. The experiments were also performed with wastewater from textile industry with an aim to examine the potential of fungal biomass for the removal of dyes from wastewater under actual field conditions. The maximum dye removal was obtained at 30° C temperature (87%) in presence of 1 % glucose concentration (89%) and 10 % inoculum concentration (91%) after 96 hours from textile wastewater. The surface of the biosorbent before and after the sorption of the dye was examined by FTIR and SEM analysis.
在本研究中,尝试利用黄曲霉在生长过程中去除 Remazol Black B 染料(偶氮染料)。在批式反应器中研究了生长真菌对偶氮染料的吸附作用,作为染料初始浓度(25-1000mg/L)、接种浓度(5-20%)和 pH 值(2.5-6.5)的函数。通过将染料浓度从 0 增加到 1000mg/L,总生物量浓度从 6.3g/L 降低到 1.44g/L。通过将初始染料浓度从 25mg/L 增加到 1000mg/L,染料的吸附量从 4.37mg/g 增加到 233mg/g 干燥生物质。在初始浓度高达 250mg/L 时,并且在 pH 值为 4.5 时,发现染料几乎可以完全去除,这被用作所有批次研究中去除染料的工作 pH 值。在 100mg/L 初始染料浓度下,化学需氧量(COD)的去除率达到 90%。还进行了从纺织工业废水中去除染料的实验,目的是检查真菌生物量在实际现场条件下从废水中去除染料的潜力。在 30°C 温度下(87%),在 1%葡萄糖浓度(89%)和 10%接种浓度(91%)存在下,经过 96 小时后,从纺织废水中获得了最大的染料去除率。在吸附染料前后,通过傅里叶变换红外光谱(FTIR)和扫描电子显微镜(SEM)分析对生物吸附剂的表面进行了检查。