Zhao Xin, Chosa Etsuo, Totoribe Koji, Deng Gang
Department of Medicine of Sensory and Motor Organs, Division of Orthopedic Surgery, Faculty of Medicine, University of Miyazaki, 5200 Kihara, Kiyotake, Miyazaki 889-1692, Japan.
J Orthop Sci. 2010 Sep;15(5):632-40. doi: 10.1007/s00776-010-1511-z. Epub 2010 Oct 16.
Finite element analysis (FEA) has been applied for the biomechanical analysis of acetabular dysplasia, but not for biomechanical studies of periacetabular osteotomy (PAO) or those performing analysis taking into consideration the severity of acetabular dysplasia. This study aimed to perform biomechanical evaluation of changes in stress distribution following PAO and to determine the effect of the severity of developmental dysplasia of the hip (DDH) using three-dimensional FEA.
A normal model was designed with a 25° center-edge (CE) angle and a 25° vertical-center-anterior margin (VCA) angle. DDH models were designed with CE and VCA angles each of 10, 0, or -10°. Post-PAO models were created by separating each DDH model and rotating the acetabular bone fragment in the anterolateral direction so that the femoral head was covered by the acetabular bone fragment, with CE and VCA angles each at 25°.
Compared to the normal hip joint model, the DDH models showed stress concentration in the acetabular edge and contacting femoral head, and higher stress values; stress increased with decreasing CE and VCA angles. Compared to the DDH models, the post-PAO models showed near-normal patterns of stress distribution in the acetabulum and femoral head, with stress concentration areas shifted from the lateral to medial sides. Stress dispersion was especially apparent in the severe acetabular dysplasia models. PAO provided greater decreases in the maximum values of von Mises stress in the load-bearing area of the acetabulum and femoral head when applied to the DDH models of higher degrees of severity, although the values increased with increasing severity of DDH.
PAO is expected to provide biomechanical improvement of the hip joint and to be particularly effective in patients with severe preoperative DDH, although the results also suggested a limitation in the applicability of PAO for these patients.
有限元分析(FEA)已应用于髋臼发育不良的生物力学分析,但尚未用于髋臼周围截骨术(PAO)的生物力学研究,也未用于考虑髋臼发育不良严重程度的分析。本研究旨在使用三维有限元分析对PAO术后应力分布变化进行生物力学评估,并确定发育性髋关节发育不良(DDH)严重程度的影响。
设计一个中心边缘(CE)角为25°、垂直中心前缘(VCA)角为25°的正常模型。DDH模型的CE角和VCA角分别设计为10°、0°或-10°。通过分离每个DDH模型并将髋臼骨块向前外侧方向旋转,使股骨头被髋臼骨块覆盖,创建PAO术后模型,其CE角和VCA角均为25°。
与正常髋关节模型相比,DDH模型在髋臼边缘和接触的股骨头处出现应力集中,且应力值更高;应力随着CE角和VCA角的减小而增加。与DDH模型相比,PAO术后模型在髋臼和股骨头处的应力分布模式接近正常,应力集中区域从外侧转移到内侧。应力分散在严重髋臼发育不良模型中尤为明显。当应用于更高严重程度的DDH模型时,PAO使髋臼和股骨头承重区域的冯·米塞斯应力最大值有更大程度的降低,尽管这些值随着DDH严重程度的增加而增加。
PAO有望改善髋关节的生物力学性能,对术前严重DDH患者尤其有效,尽管结果也表明PAO对这些患者的适用性存在局限性。