London Regional Cancer Program, London Health Sciences Centre, London, ON, Canada.
Phys Med Biol. 2010 Nov 21;55(22):6673-94. doi: 10.1088/0031-9155/55/22/006. Epub 2010 Oct 28.
Gated radiotherapy of lung lesions is particularly complex for helical tomotherapy, due to the simultaneous motions of its three subsystems (gantry, couch and collimator). We propose a new way to implement gating for helical tomotherapy, namely multi-pass respiratory gating. In this method, gating is achieved by delivering only the beam projections that occur within a respiratory gating window, while blocking the rest of the beam projections by fully closing all collimator leaves. Due to the continuous couch motion, the planned beam projections must be delivered over multiple passes of radiation deliveries. After each pass, the patient couch is reset to its starting position, and the treatment recommences at a different phase of tumour motion to 'fill in' the previously blocked beam projections. The gating process may be repeated until the plan dose is delivered (full gating), or halted after a certain number of passes, with the entire remaining dose delivered in a final pass without gating (partial gating). The feasibility of the full gating approach was first tested for sinusoidal target motion, through experimental measurements with film and computer simulation. The optimal gating parameters for full and partial gating methods were then determined for various fractionation schemes through computer simulation, using a patient respiratory waveform. For sinusoidal motion, the PTV dose deviations of -29 to 5% observed without gating were reduced to range from -1 to 3% for a single fraction, with a 4 pass full gating. For a patient waveform, partial gating required fewer passes than full gating for all fractionation schemes. For a single fraction, the maximum allowed residual motion was only 4 mm, requiring large numbers of passes for both full (12) and partial (7 + 1) gating methods. The number of required passes decreased significantly for 3 and 30 fractions, allowing residual motion up to 7 mm. Overall, the multi-pass gating technique was shown to be a promising way to reduce the impact of lung tumour motion during helical tomotherapy.
肺部病变的门控放射治疗对螺旋断层放疗来说尤其复杂,这是因为其三个子系统(机架、治疗床和准直器)同时运动。我们提出了一种实现螺旋断层放疗门控的新方法,即多轮呼吸门控。在这种方法中,通过仅传输在呼吸门控窗内的射束投影来实现门控,同时通过完全关闭所有准直器叶片来阻止其余的射束投影。由于连续的治疗床运动,必须通过多次放射传输来传输计划的射束投影。每次传输后,重置患者治疗床到起始位置,并在肿瘤运动的不同相位开始新的一轮治疗以“填补”先前被阻挡的射束投影。门控过程可以重复,直到完成计划剂量的传输(全门控),或者在经过一定次数的传输后停止,其余的整个剂量在没有门控的最后一轮传输中完成(部分门控)。通过实验测量胶片和计算机模拟,首先对正弦靶运动的全门控方法的可行性进行了测试。然后通过计算机模拟,使用患者呼吸波形,确定了各种分割方案下全门控和部分门控方法的最佳门控参数。对于正弦运动,在没有门控的情况下,PTV 剂量偏差从-29%到 5%,通过 4 轮全门控减少到 1 轮时的-1%到 3%。对于患者波形,对于所有分割方案,部分门控所需的传输轮次都少于全门控。对于单次分割,最大允许残余运动仅为 4mm,对于全门控(12 轮)和部分门控(7+1 轮)方法,都需要大量的传输轮次。对于 3 次和 30 次分割,所需的传输轮次显著减少,允许残余运动达到 7mm。总的来说,多轮门控技术是一种很有前途的方法,可以减少肺部肿瘤运动对螺旋断层放疗的影响。