Chemical Physics of Materials, Université Libre de Bruxelles, Faculté des Sciences, Campus Plaine, CP 243, B-1050 Brussels, Belgium.
Ultramicroscopy. 2011 May;111(6):376-80. doi: 10.1016/j.ultramic.2010.10.022. Epub 2010 Nov 11.
The adsorption of NO and its reaction with H(2) over Pd tips were investigated by means of field ion microscopy (FIM) and pulsed field desorption mass spectrometry (PFDMS) in the 10(-3)Pa pressure range and at sample temperatures between 400 and 600K. By varying the H(2) partial pressure while keeping the other control parameters constant, the NO+H(2) reaction over Pd crystallites is shown to exhibit a strong hysteresis effect. The hysteresis region narrows with increase in temperature and the H(2) pressures delimiting this hysteresis decrease as well. Abrupt transformations of the micrographs are observed by FIM from bright to dark patterns and vice versa. These transformations define the hysteresis region. The collected data allow establishing a novel kinetic phase diagram of the NO+H(2)/Pd system within the range of temperatures and pressures indicated. The observed features are correlated with a local chemical analysis by means of field pulses. NO(+) seems to be the dominating imaging species under all conditions. At high relative H(2) pressures (the "hydrogen-side"), H atoms seem to diffuse subsurface. This process is blocked at lower H(2) pressure (the "NO-side") due to NO(ad) and O(ad) accumulation on the surface. Probe-hole measurements with field pulses indicate that the Pd surface undergoes oxidation as revealed by the occurrence of PdO(2)(+) species in the mass spectra.
采用场离子显微镜(FIM)和脉冲场解吸质谱(PFDMS)在 10^(-3)Pa 压力范围和 400 至 600K 的样品温度下,研究了 Pd 尖端上的 NO 的吸附及其与 H(2)的反应。通过在保持其他控制参数不变的情况下改变 H(2)分压,发现 Pd 晶粒上的 NO+H(2)反应表现出强烈的滞后效应。随着温度的升高,滞后区变窄,限定该滞后区的 H(2)压力也降低。FIM 从亮到暗的图案的突然转变观察到微图的转变。这些转变定义了滞后区。所收集的数据允许在所示的温度和压力范围内为 NO+H(2)/Pd 系统建立一个新的动力学相图。观察到的特征与通过场脉冲进行的局部化学分析相关。在所有条件下,NO(+)似乎都是主要的成像物种。在相对较高的 H(2)压力下(“氢侧”),H 原子似乎在表面下扩散。由于表面上的 NO(ad)和 O(ad)积累,在较低的 H(2)压力下(“NO 侧”),这个过程被阻止。场脉冲的探针孔测量表明,Pd 表面发生氧化,质谱中出现了 PdO(2)(+)物种。