Dept. of Environmental Sciences, Weizmann Institute, Rehovot 76100, Israel.
Phys Chem Chem Phys. 2011 Apr 14;13(14):6484-92. doi: 10.1039/c0cp02114h. Epub 2011 Mar 3.
Chemical reactions can alter the chemical, physical, and optical properties of aerosols. It has been postulated that nitration of aerosols can account for atmospheric absorbance over urban areas. To study this potentially important process, the change in optical properties of laboratory-generated benzo[a]pyrene (BaP)-coated aerosols following exposure to NO(2) and NO(3) was investigated at 355 nm and 532 nm by three aerosol analysis techniques. The extinction coefficient was determined at 355 nm and 532 nm from cavity ring-down aerosol spectroscopy (CRD-AS); the absorption coefficient was measured by photoacoustic spectroscopy (PAS) at 532 nm, while an on-line aerosol mass spectrometer (AMS) supplied real-time quantitative information about the chemical composition of aerosols. In this study, 240 nm polystyrene latex (PSL) spheres were thinly coated with BaP to form 300 or 310 nm aerosols that were exposed to high concentrations of NO(2) and NO(3) and measured with CRD-AS, PAS, and the AMS. The extinction efficiencies (Q(ext)) changed after exposure to NO(2) and NO(3) at both wavelengths. Prior to reaction, Q(ext) for the 355 nm and 532 nm wavelengths were 4.36 ± 0.04 and 2.39 ± 0.05, respectively, and Q(ext) increased to 5.26 ± 0.04 and 2.79 ± 0.05 after exposure. The absorption cross-section at 532 nm, determined with PAS, reached σ(abs) = (0.039 ± 0.001) × 10(-8) cm(2), indicating that absorption increased with formation of nitro-BaP, the main reaction product detected by the AMS. The single-scattering albedo (SSA), a measure of particle scattering efficiency, decreased from 1 to 0.85 ± 0.03, showing that changes in the optical properties of BaP-covered aerosols due to nitration may have implications for regional radiation budget and, hence, climate.
化学反应可以改变气溶胶的化学、物理和光学性质。有人假设,气溶胶的硝化作用可以解释城市地区大气的吸收。为了研究这一潜在重要的过程,研究了在 355nm 和 532nm 下,通过三种气溶胶分析技术,实验室生成的苯并[a]芘(BaP)涂层气溶胶暴露于 NO(2)和 NO(3)后光学性质的变化。消光系数在 355nm 和 532nm 下由腔衰荡气溶胶光谱(CRD-AS)确定;在 532nm 下通过光声光谱(PAS)测量吸收系数,而在线气溶胶质谱仪(AMS)实时提供气溶胶化学成分的定量信息。在这项研究中,240nm 聚苯乙烯乳胶(PSL)球被薄薄地涂覆了 BaP,形成了 300 或 310nm 的气溶胶,这些气溶胶暴露在高浓度的 NO(2)和 NO(3)下,并通过 CRD-AS、PAS 和 AMS 进行了测量。暴露于 NO(2)和 NO(3)后,两个波长的消光效率(Q(ext))都发生了变化。在反应之前,355nm 和 532nm 波长的 Q(ext)分别为 4.36 ± 0.04 和 2.39 ± 0.05,暴露后增加到 5.26 ± 0.04 和 2.79 ± 0.05。用 PAS 确定的 532nm 吸收截面达到 σ(abs) = (0.039 ± 0.001) × 10(-8) cm(2),表明吸收随着硝化产物硝基-BaP 的形成而增加,这是 AMS 检测到的主要反应产物。单散射反照率(SSA),一种衡量粒子散射效率的指标,从 1 降低到 0.85 ± 0.03,表明由于硝化作用,BaP 覆盖的气溶胶光学性质的变化可能对区域辐射预算有影响,进而对气候有影响。