Suppr超能文献

人体前交叉韧带三束的力学功能。

Mechanical functions of the three bundles consisting of the human anterior cruciate ligament.

机构信息

Biomechanics Laboratory, Faculty of System Design, Tokyo Metropolitan University, Tokyo, Japan.

出版信息

Knee Surg Sports Traumatol Arthrosc. 2011 Dec;19 Suppl 1:S47-53. doi: 10.1007/s00167-011-1513-1. Epub 2011 May 4.

Abstract

PURPOSE

The reconstruction technique to individually reconstruct multi-bundles of the anterior cruciate ligament (ACL) has been improved in the last decade. For further improvement of the technique, the present study was conducted to determine the force sharing among the three bundles (the medial and lateral bundles (AMM and AML) of the anteromedial (AM) bundle and the posterlateral (PL) bundle) of the human ACL in response to hyperextension, passive flexion-extension and anterior force to the knee.

METHODS

Using a 6-DOF robotic system, the human cadaveric knee specimens were subjected to hyperextension, passive flexion-extension and anterior-posterior tests, while recording the 6-DOF motion and force/moment of the knees. The intact knee motions recorded during the tests were reproduced after sequential bundle transection to determine the bundle forces.

RESULTS

The bundle forces were around 10 N at 5 N-m of hyperextension and remained less than 5 N during passive flexion-extension. In response to 100 N of anterior force, the AMM and PL bundle forces were slightly higher than the AML bundle force at full extension. The AMM bundle force remained at a high level up to 90° of flexion, with significant differences versus the AML bundle force at 15°, 30° and 60° of flexion and the PL bundle force at 90° of flexion.

CONCLUSION

The AMM bundle is the primary stabilizer to tibial anterior drawer through wide range of motion, while the AML bundle is the secondary stabilizer in deep flexion angles. The PL bundle is the crucial stabilizer to hyperextension as well as tibial anterior drawer at full extension.

摘要

目的

在过去十年中,已经改进了单独重建前交叉韧带(ACL)多束的重建技术。为了进一步改进该技术,本研究旨在确定在膝关节过伸、被动屈伸和前向力作用下,ACL 的三个束(前内侧束的内侧和外侧束(AMM 和 AML)和后外侧束(PL))之间的力分配。

方法

使用 6-DOF 机器人系统,对人体尸体膝关节标本进行过伸、被动屈伸和前后测试,同时记录膝关节的 6-DOF 运动和力/力矩。在进行束序切断以确定束力后,重现测试过程中记录的完整膝关节运动。

结果

在 5 N-m 的过伸时,束力约为 10 N,在被动屈伸时保持在 5 N 以下。在 100 N 的前向力作用下,AMM 和 PL 束力在完全伸展时略高于 AML 束力。AMM 束力在 90°的屈曲时保持在较高水平,与 AML 束力在 15°、30°和 60°的屈曲以及 PL 束力在 90°的屈曲时存在显著差异。

结论

AMM 束是在宽运动范围内对胫骨前抽屉的主要稳定器,而 AML 束是在深屈曲角度的次要稳定器。PL 束是过伸以及完全伸展时胫骨前抽屉的关键稳定器。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验