Elias John J, Kirkpatrick Marcus S, Saranathan Archana, Mani Saandeep, Smith Laura G, Tanaka Miho J
Department of Orthopaedic Surgery, Akron General Medical Center, OH, USA.
Clin Biomech (Bristol). 2011 Oct;26(8):841-6. doi: 10.1016/j.clinbiomech.2011.03.016. Epub 2011 May 4.
Hamstrings loading has previously been shown to increase tibiofemoral posterior translation and external rotation, which could contribute to patellofemoral malalignment and elevated patellofemoral pressures. The current study characterizes the influence of forces applied by the hamstrings on patellofemoral kinematics and the pressure applied to patellofemoral cartilage.
Ten knees were positioned at 40°, 60° and 80° of flexion in vitro, and loaded with 586 N applied through the quadriceps, with and without an additional 200 N applied through the hamstrings. Patellofemoral kinematics were characterized with magnetic sensors fixed to the patella and the femur, while the pressure applied to lateral and medial patellofemoral cartilage was measured with pressure sensors. A repeated measures ANOVA with three levels, combined with paired t-tests at each flexion angle, determined if loading the hamstrings significantly (P<0.05) influenced the output.
Loading the hamstrings increased the average patellar flexion, lateral tilt and lateral shift by approximately 1°, 0.5° and 0.2mm, respectively. Each increase was significant for at least two flexion angles. Loading the hamstrings increased the percentage of the total contact force applied to lateral cartilage by approximately 5%, which was significant at each flexion angle, and the maximum lateral pressure by approximately 0.3 MPa, which was significant at 40° and 60°.
The increased lateral shift and tilt of the patella caused by loading the hamstrings can contribute to lateral malalignment and shifts pressure toward the lateral facet of the patella, which could contribute to overloading of lateral cartilage.
先前的研究表明,腘绳肌加载会增加胫股关节的后向平移和外旋,这可能导致髌股关节排列不齐以及髌股关节压力升高。本研究旨在描述腘绳肌施加的力对髌股关节运动学以及髌股关节软骨所受压力的影响。
在体外将10个膝关节分别置于40°、60°和80°的屈曲角度,通过股四头肌施加586 N的负荷,分别在有和没有通过腘绳肌额外施加200 N负荷的情况下进行测试。使用固定在髌骨和股骨上的磁传感器来表征髌股关节的运动学,同时使用压力传感器测量髌股关节外侧和内侧软骨所受的压力。采用三水平重复测量方差分析,并结合每个屈曲角度的配对t检验,以确定腘绳肌加载是否对输出有显著影响(P<0.05)。
加载腘绳肌分别使髌骨平均屈曲、外侧倾斜和外侧移位增加了约1°、0.5°和0.2mm。每种增加在至少两个屈曲角度下均具有显著性。加载腘绳肌使施加于外侧软骨的总接触力百分比增加了约5%,在每个屈曲角度下均具有显著性,并且最大外侧压力增加了约0.3 MPa,在40°和60°时具有显著性。
加载腘绳肌导致的髌骨外侧移位和倾斜增加,可能会导致外侧排列不齐,并使压力向髌骨外侧小面转移,这可能会导致外侧软骨过载。