Department of Agronomy, Kansas State University, Manhattan, KS 66506, USA.
Hereditas. 2011 Jun;148(3):98-109. doi: 10.1111/j.1601-5223.2011.02229.x. Epub 2011 Jun 16.
The Ethio-Sudan region is recognized as the center of origin and diversity for cultivated sorghum. All major races of the crop are widely grown in Ethiopia with durras being dominant. The objective of the present study was to determine the extent of morphological variability among the Ethiopian durras and examine the pattern of relationships among these traits and their association with yield and yield components. Two hundred accessions collected from major sorghum-growing regions of the country were evaluated during the 2007 season at two locations representing hot and dry low land and mild mid-altitude environments. A randomized complete block design with three replications was used. Data were collected on phenology, plant height, a range of leaf traits and yield components. Significant variation was observed among all traits measured. Phenological traits and plant height were significantly correlated with each other and with all leaf traits. There was positive correlation among leaf traits, and between leaf traits and yield components except thousand kernel weight (TKW) and panicle length (PL). Grain fill duration was negatively correlated with all traits except days to maturity, TKW, and leaf length. Yield components except PL and TKW were positively correlated with each other. Selection that focuses on key yield components, larger leaf area, and on enhancing the grain filling rate by reducing excessive grain fill duration may contribute to yield improvement.
埃塞俄比亚-苏丹地区被认为是栽培高粱的起源和多样性中心。所有主要的高粱品种都在埃塞俄比亚广泛种植,其中杜拉品种占主导地位。本研究的目的是确定埃塞俄比亚杜拉高粱的形态变异程度,并研究这些性状之间的关系模式及其与产量和产量构成的关联。在 2007 年的季节,从该国主要高粱种植地区收集的 200 个品种在代表炎热干旱低地和温和中海拔环境的两个地点进行了评估。采用随机完全区组设计,设三个重复。收集了物候学、株高、一系列叶片性状和产量构成的相关数据。所有测量的性状都表现出显著的差异。物候学性状和株高彼此之间以及与所有叶片性状都呈显著相关。叶片性状之间存在正相关,叶片性状与产量构成之间也存在正相关,但千粒重(TKW)和穗长(PL)除外。灌浆持续时间与除成熟天数、TKW 和叶长外的所有性状呈负相关。除 PL 和 TKW 外,产量构成之间都呈正相关。对关键产量构成、更大的叶面积以及通过减少过度的灌浆持续时间来提高灌浆速率的选择可能有助于提高产量。