Pereira Barry P, Thambyah Ashvin, Lee Taeyong
Musculoskeletal Research Laboratories, Department of Orthopaedic Surgery, Yong Loo Lin School of Medicine, National University of Singapore, Singapore.
J Appl Biomech. 2012 May;28(2):127-38. doi: 10.1123/jab.28.2.127. Epub 2011 Aug 26.
This study investigates the altered thoracohumeral kinematics when forearm rotation is restricted while performing five activities requiring pronation and supination. Two splints simulated both a fixed-supinated or fixed-neutral forearm in six healthy subjects; the three-dimensional coupled relationship among motion about the forearm, elbow, and shoulder were analyzed. In using a screwdriver, the normal range of forearm rotation of 77.6° (SD = 30.8°) was reduced in the fixed-supinated to 11.3° (SD = 2.9°) and fixed-neutral to 18.2° (SD = 6.2°). This restriction from the fixed-supinated and fixed-neutral forearms was compensated at the shoulder by a significant increase in the total range of (1) ad/abduction by 57.3° and 62.8° respectively (p < .001), (2) forward-reverse flexion (24.3° and 18.2° respectively; p < .05) and (3) internal-external rotation (37.1° and 44.2° respectively; p < .001). A similar result was demonstrated for the doorknob activity. The elbow did not significantly contribute to forearm rotation (p = .14), and is believed to be due to the elbow axis being orthogonal and oblique to the forearm axis. For open kinetic-chain activities, with a fixed-supinated forearm performing there was a significant coupled increase in ad/abduction (p < .05) and int/external rotation (p < .05) for the phone and feeding tasks, with the phone task also having a significantly increased forward shoulder flexion (p < .05). For the fixed-neutral forearm, significant compensatory movement was only seen in the feeding task with increased ad/abduction and internal-external shoulder rotation (p < .05) and the card inserting task with increased ad/abduction and forward-reverse shoulder flexion. Limited forearm function requires compensatory motion from adjacent joints to perform activities that require pronation and supination.
本研究调查了在进行五项需要旋前和旋后的活动时,当限制前臂旋转时胸肱运动学的改变。在六名健康受试者中,使用两种夹板模拟固定旋后或固定中立位的前臂;分析了前臂、肘部和肩部运动之间的三维耦合关系。在使用螺丝刀时,正常前臂旋转范围77.6°(标准差=30.8°)在固定旋后位减少到11.3°(标准差=2.9°),在固定中立位减少到18.2°(标准差=6.2°)。固定旋后位和固定中立位前臂造成的这种限制在肩部得到补偿,具体表现为:(1)内收/外展总范围分别显著增加57.3°和62.8°(p<0.001);(2)前屈-后伸分别增加24.3°和18.2°(p<0.05);(3)内旋-外旋分别增加37.1°和44.2°(p<0.001)。门把手活动也得到了类似结果。肘部对前臂旋转的贡献不显著(p=0.14),据信这是由于肘部轴线与前臂轴线正交且倾斜。对于开链运动,在进行电话任务和喂食任务时,固定旋后位的前臂会导致内收/外展(p<0.05)和内旋/外旋(p<0.05)显著耦合增加,电话任务还会使肩部前屈显著增加(p<0.05)。对于固定中立位的前臂,仅在喂食任务中出现显著的代偿性运动,表现为内收/外展和肩部内旋-外旋增加(p<0.05),以及在插卡任务中出现内收/外展和肩部前屈-后伸增加。有限的前臂功能需要相邻关节进行代偿性运动,以完成需要旋前和旋后的活动。