McManus Madonna M, Grill Raymond J
Department of Integrative Biology and Pharmacology, University of Texas Health Science Center at Houston, USA.
J Vis Exp. 2011 Dec 7(58):3246. doi: 10.3791/3246.
Spinal cord injury (SCI) is often accompanied by osteoporosis in the sublesional regions of the pelvis and lower extremities, leading to a higher frequency of fractures. As these fractures often occur in regions that have lost normal sensory function, the patient is at a greater risk of fracture-dependent pathologies, including death. SCI-dependent loss in both bone mineral density (BMD, grams/cm2) and bone mineral content (BMC, grams) has been attributed to mechanical disuse, aberrant neuronal signaling and hormonal changes. The use of rodent models of SCI-induced osteoporosis can provide invaluable information regarding the mechanisms underlying the development of osteoporosis following SCI as well as a test environment for the generation of new therapies. Mouse models of SCI are of great interest as they permit a reductionist approach to mechanism-based assessment through the use of null and transgenic mice. While such models have provided important data, there is still a need for minimally-invasive, reliable, reproducible, and quantifiable methods in determining the extent of bone loss following SCI, particularly over time and within the same cohort of experimental animals, to improve diagnosis, treatment methods, and/or prevention of SCI-induced osteoporosis. An ideal method for measuring bone density in rodents would allow multiple, sequential (over time) exposures to low-levels of X-ray radiation. This study describes the use of a new whole-animal scanner, the IVIS Lumina XR (Caliper Instruments) that can be used to provide low-energy (1-3 milligray (mGy)) high-resolution, high-magnification X-ray images of mouse hind limb bones over time following SCI. Significant bone density loss was seen in the tibiae of mice by 10 days post-spinal transection when compared to uninjured, age-matched control (naïve) mice (13% decrease, p < 0.0005). Loss of bone density in the distal femur was also detectable by day 10 post-SCI, while a loss of density in the proximal femur was not detectable until 40 days post injury (7% decrease, p < 0.05). SCI-dependent loss of mouse femur density was confirmed post-mortem through the use of Dual-energy X-ray Absorptiometry (DXA), the current "gold standard" for bone density measurements. We detect a 12% loss of BMC in the femurs of mice at 40 days post-SCI using the IVIS Lumina XR. This compares favorably with a previously reported BMC loss of 13.5% by Picard and colleagues who used DXA analysis on mouse femurs post-mortem 30 days post-SCI (9). Our results suggest that the IVIS Lumina XR provides a novel, high-resolution/high-magnification method for performing long-term, longitudinal measurements of hind limb bone density in the mouse following SCI.
脊髓损伤(SCI)常伴有骨盆和下肢损伤平面以下区域的骨质疏松,导致骨折发生率更高。由于这些骨折常发生在失去正常感觉功能的区域,患者发生与骨折相关的病症(包括死亡)的风险更大。SCI导致的骨矿物质密度(BMD,克/平方厘米)和骨矿物质含量(BMC,克)损失归因于机械性废用、异常的神经元信号传导和激素变化。使用SCI诱导的骨质疏松症啮齿动物模型可以提供有关SCI后骨质疏松症发生机制的宝贵信息,以及用于开发新疗法的测试环境。SCI小鼠模型备受关注,因为它们允许通过使用基因敲除小鼠和转基因小鼠对基于机制的评估采用简化方法。虽然此类模型已提供了重要数据,但仍需要微创、可靠、可重复和可量化的方法来确定SCI后骨丢失的程度,尤其是随时间推移以及在同一组实验动物中的骨丢失程度,以改善SCI诱导的骨质疏松症的诊断、治疗方法和/或预防。一种用于测量啮齿动物骨密度的理想方法应允许对低水平X射线辐射进行多次、连续(随时间)照射。本研究描述了一种新型的全动物扫描仪IVIS Lumina XR(卡尺仪器公司)的使用,该扫描仪可用于在SCI后随时间对小鼠后肢骨骼提供低能量(1 - 3毫戈瑞(mGy))的高分辨率、高放大倍数的X射线图像。与未受伤、年龄匹配的对照(未处理)小鼠相比,脊髓横断后10天,小鼠胫骨出现明显的骨密度损失(降低13%,p < 0.0005)。SCI后第10天也可检测到股骨远端的骨密度损失,而股骨近端的密度损失直到损伤后40天才可检测到(降低7%,p < 0.05)。通过使用双能X射线吸收法(DXA)(目前骨密度测量的“金标准”)在死后证实了SCI导致的小鼠股骨密度损失。使用IVIS Lumina XR,我们在SCI后40天检测到小鼠股骨的BMC损失了12%。这与皮卡德及其同事先前报道的结果相比具有优势,他们在SCI后30天对小鼠股骨进行死后DXA分析,发现BMC损失了13.5%。我们的结果表明,IVIS Lumina XR为SCI后小鼠后肢骨密度的长期纵向测量提供了一种新颖的高分辨率/高放大倍数方法。