Medical Physics, Sant'Andrea Hospital, Rome, Italy.
Cancer Biother Radiopharm. 2012 Mar;27(2):124-33. doi: 10.1089/cbr.2011.1063. Epub 2012 Jan 27.
Aim of the present article was to perform three-dimensional (3D) single photon emission tomography-based dosimetry in radioimmunotherapy (RIT) with (90)Y-ibritumomab-tiuxetan. A custom MATLAB-based code was used to elaborate 3D images and to compare average 3D doses to lesions and to organs at risk (OARs) with those obtained with planar (2D) dosimetry. Our 3D dosimetry procedure was validated through preliminary phantom studies using a body phantom consisting of a lung insert and six spheres with various sizes. In phantom study, the accuracy of dose determination of our imaging protocol decreased when the object volume decreased below 5 mL, approximately. The poorest results were obtained for the 2.58 mL and 1.30 mL spheres where the dose error evaluated on corrected images with regard to the theoretical dose value was -12.97% and -18.69%, respectively. Our 3D dosimetry protocol was subsequently applied on four patients before RIT with (90)Y-ibritumomab-tiuxetan for a total of 5 lesions and 4 OARs (2 livers, 2 spleens). In patient study, without the implementation of volume recovery technique, tumor absorbed doses calculated with the voxel-based approach were systematically lower than those calculated with the planar protocol, with average underestimation of -39% (range from -13.1% to -62.7%). After volume recovery, dose differences reduce significantly, with average deviation of -14.2% (range from -38.7.4% to +3.4%, 1 overestimation, 4 underestimations). Organ dosimetry in one case overestimated, in the other underestimated the dose delivered to liver and spleen. However, both for 2D and 3D approach, absorbed doses to organs per unit administered activity are comparable with most recent literature findings.
目的 本研究旨在进行基于单光子发射断层扫描的 90Y-替伊莫单抗替曲膦放射免疫治疗(RIT)的三维(3D)剂量测定,并将其与平面(2D)剂量测定进行比较。我们使用基于 MATLAB 的定制代码来详细说明 3D 图像,并比较病变和危及器官(OAR)的平均 3D 剂量与 2D 剂量测定结果。通过使用包含肺插入物和六个具有不同大小球体的体模进行初步体模研究,验证了我们的 3D 剂量测定程序。在体模研究中,当物体体积减小到 5 毫升以下时,我们的成像方案的剂量测定准确性降低,大约如此。对于 2.58 毫升和 1.30 毫升的球体,获得的结果最差,校正图像上的剂量误差相对于理论剂量值分别为-12.97%和-18.69%。随后,我们将 3D 剂量测定方案应用于 4 例接受 90Y-替伊莫单抗替曲膦治疗的患者,共 5 个病灶和 4 个 OAR(2 个肝脏,2 个脾脏)。在患者研究中,在没有实施体积恢复技术的情况下,基于体素的方法计算的肿瘤吸收剂量系统低于平面协议计算的吸收剂量,平均低估了-39%(范围为-13.1%至-62.7%)。进行体积恢复后,剂量差异显著减小,平均偏差为-14.2%(范围为-38.7.4%至+3.4%,1 个高估,4 个低估)。在一个病例中,对肝脏和脾脏的剂量高估,而在另一个病例中,剂量低估。然而,对于 2D 和 3D 方法,单位给予活性的器官吸收剂量与最近的文献发现相当。