School of Environmental Science and Engineering, SunYat-sen University, Guangzhou, China.
Environ Sci Technol. 2012 Mar 20;46(6):3312-8. doi: 10.1021/es204094v. Epub 2012 Feb 28.
A new method for stable carbon isotope ratio analysis of anhydrosugars from biomass burning aerosol particle source filter samples was developed by employing Thermal Desorption--2 Dimensional Gas Chromatography--Isotope Ratio Mass Spectrometry (TD-2DGC-IRMS). Compound specific isotopic measurements of levoglucosan, mannosan, and galactosan performed by TD-2DGC-IRMS in a standard mixture show good agreement with isotopic measurements of the bulk anhydrosugars, carried out by Elemental Analyzer--Isotope Ratio Mass Spectrometry (EA-IRMS). The established method was applied to determine the isotope ratios of levoglucosan, mannosan, and galactosan from source samples collected during combustion of hard wood, softwood, and crop residues. δ(13)C values of levoglucosan were found to vary between -25.6 and -22.2‰, being higher in the case of softwood. Mannosan and galactosan were detected only in the softwood samples showing isotope ratios of -23.5‰ (mannosan) and -25.7‰ (galactosan). The isotopic composition of holocellulose in the plant material used for combustion experiments was determined with δ(13)C values between -28.5 and -23.7‰. The difference in δ(13)C of levoglucosan in biomass burning aerosol particles compared to the parent fuel holocellulose was found to be -1.89 (±0.37)‰ for the investigated biomass fuels. Compound specific δ(13)C measurements of anhydrosugars should contribute to an improved source apportionment.
采用热脱附-二维气相色谱-同位素比质谱法(TD-2DGC-IRMS),开发了一种从生物质燃烧气溶胶颗粒源滤膜样品中分析无水糖的稳定碳同位素比的新方法。TD-2DGC-IRMS 对标准混合物中左旋葡聚糖、甘露聚糖和半乳糖的化合物特异性同位素测量与元素分析仪-同位素比质谱法(EA-IRMS)对无水糖的同位素测量吻合良好。所建立的方法用于测定硬木、软木和农作物燃烧源样品中左旋葡聚糖、甘露聚糖和半乳糖的同位素比值。左旋葡聚糖的δ(13)C 值在-25.6 至-22.2‰之间变化,在软木中较高。仅在软木样品中检测到甘露聚糖和半乳糖,其同位素比值分别为-23.5‰(甘露聚糖)和-25.7‰(半乳糖)。燃烧实验中所用植物材料的全纤维素的同位素组成用δ(13)C 值在-28.5 至-23.7‰之间确定。生物质燃烧气溶胶颗粒中左旋葡聚糖的δ(13)C 值与母燃料全纤维素的δ(13)C 值之差为-1.89(±0.37)‰,对于所研究的生物质燃料而言。无水糖的化合物特异性 δ(13)C 测量应该有助于改进源分配。