Department of Orthopedic Surgery, Mayo Clinic, 200 First Street SW, Rochester, MN, USA.
Spine (Phila Pa 1976). 2012 Feb 15;37(4):340-5. doi: 10.1097/BRS.0b013e31821946d1.
Imaging supine sagittal alignment study.
Our goal was to determine differences between plain radiographs and computed tomography (CT) scans in supine sagittal alignment and to establish supine reference Cobb angles for both.
Few studies have compared plain radiographs versus CT scans with regard to sagittal spine alignment. None have utilized supine patients.
Fifty sequential blunt trauma individuals who had routine clearance of the thoracolumbar spine had their plain radiographs and CT scans reviewed independently by 2 spine surgeons. The Cobb method was utilized to determine angles at each spine level from T4 to L5. All imaging was obtained in the supine position, and no patient had acute ligamentous or bony pathology. Intraclass correlation coefficients (ICCs) were utilized to determine intraobserver, interobserver, and method reliability.
Every level within the thoracic region was kyphotic, with a peak at T6. The lumbar region demonstrated a fairly linear progression from a near-neutral alignment at L1 to approximately 50° of lordosis at L5. The intraobserver reliability was consistent, with ICCs for Observer 1 plain radiographs at 0.653, Observer 2 plain radiographs at 0.891, Observer 1 CT scans at 0.677, and Observer 2 CT scans at 0.648. The interobserver reliability was very high, with ICCs for plain radiographs at 0.902 and 0.895 for CT scans. Finally, method reliability (between plain radiographs and CT scans) was excellent as well, with ICCs of 0.808 for Observer 1, 0.781 for Observer 2, and 0.817 after averaging the 2 observers.
The results from this study provide a supine reference for sagittal spine alignment using the Cobb method for both CT scans and plain radiographs. It also demonstrates the high degree of reliability between measurements from 2 imaging sources and various observers as shown with the ICC values.
仰卧矢状位排列研究。
我们的目标是确定仰卧位时 X 线平片和 CT 扫描在矢状位排列上的差异,并建立两者的仰卧位参考 Cobb 角。
很少有研究比较 X 线平片与 CT 扫描在脊柱矢状位排列方面的差异。没有研究利用过仰卧位患者。
50 例连续的钝器创伤患者进行了胸腰椎常规减压,由 2 名脊柱外科医生独立对他们的 X 线平片和 CT 扫描进行了评估。使用 Cobb 法在 T4 到 L5 每个脊柱水平上确定角度。所有影像学检查均在仰卧位进行,且无患者有急性韧带或骨病。采用组内相关系数(ICC)来确定观察者内、观察者间和方法的可靠性。
胸段每个节段都呈后凸畸形,在 T6 处达到高峰。腰椎段从 L1 接近中立位到 L5 约 50°的前凸呈线性变化。观察者内的可靠性是一致的,观察者 1 的 X 线平片的 ICC 为 0.653,观察者 2 的 X 线平片的 ICC 为 0.891,观察者 1 的 CT 扫描的 ICC 为 0.677,观察者 2 的 CT 扫描的 ICC 为 0.648。观察者间的可靠性非常高,X 线平片的 ICC 为 0.902,CT 扫描的 ICC 为 0.895。最后,方法可靠性(X 线平片和 CT 扫描之间)也非常好,观察者 1 的 ICC 为 0.808,观察者 2 的 ICC 为 0.781,2 位观察者平均后的 ICC 为 0.817。
本研究结果为 CT 扫描和 X 线平片使用 Cobb 法提供了仰卧位脊柱矢状位排列的参考值。它还表明,2 种成像源和不同观察者之间的测量值具有很高的可靠性,这一点可以从 ICC 值看出。