Suppr超能文献

在采用涂抹棒进行涂布时,由于涂布棒使用程度的不同,活菌的回收率会出现不同程度的差异。本文提出了一种替代划线涂布的方法,通过点样涂布,可使 CFU 最大化。

Nonrecovery of varying proportions of viable bacteria during spread plating governed by the extent of spreader usage and proposal for an alternate spotting-spreading approach to maximize the CFU.

机构信息

Division of Biotechnology, Indian Institute of Horticultural Research, Hessarghatta Lake, Bangalore, India.

出版信息

J Appl Microbiol. 2012 Aug;113(2):339-50. doi: 10.1111/j.1365-2672.2012.05327.x. Epub 2012 May 25.

Abstract

AIMS

To elucidate the cause of high variations and inconsistencies in bacterial CFU observed within and between different experiments while assessing viable bacterial counts through spread plating (SP).

METHODS AND RESULTS

Following the inconsistent results, CFU estimations were undertaken through conventional SP using the spreader, or a modified approach that did not use spreader employing four organisms. The latter approach involving spotting-and-tilt-spreading of inoculum on agar surface [spotting spreading (SS)] yielded higher CFU by 11-120% over the weighted average depending on the organism and diluent. The adverse effect owing to the spreader was the most obvious in Escherichia coli followed by Staphylococcus epidermidis, Enterobacter cloacae and Bacillus pumilus. Plate attributes that determined the surface moisture levels of agar medium and the spreading practice adopted by the personnel formed two other major influencing factors. Plating for shorter periods (<60 s) using fresh 15/20 ml plates caused loss of 3-12% CFU owing to inoculum adhesion to spreader irrespective of glass or polypropylene make. On the other hand, prolonging the plating brought down the CFU significantly. Spreader movement on agar surface subsequent to the exhaustion of free moisture, which was marked by the experiencing of some friction to smooth spreader movement, was detrimental to vegetative cells, while Bacillus spores were less affected.

CONCLUSIONS

The study brings out that the way SP is carried out exerts significant effects on CFU influenced by plate conditions. Prolonged use of spreader on dry agar surface could be highly detrimental to bacterial cells. A mild use of spreader accounting for spreader-adhering inoculum or the practice of SS not involving the spreader is recommended.

SIGNIFICANCE AND IMPACT OF THE STUDY

This study unravels the effects owing to the spreader on bacterial cells and the CFU and recommends an alternate approach of SS to minimize CFU inconsistencies and to maximize the viable bacterial counts.

摘要

目的

通过涂布平板法(SP)评估活菌计数时,阐明在评估活菌计数时,在不同实验中观察到的细菌 CFU 变化大和不一致的原因。

方法和结果

在结果不一致后,使用涂布器进行了 CFU 估计,或采用了不使用涂布器的改良方法,该方法不使用涂布器,使用了四种生物。后一种方法涉及在琼脂表面上点样和倾斜接种(点样涂布(SS)),根据生物体和稀释剂的不同,CFU 增加了 11-120%。由于使用了涂布器,对大肠杆菌的影响最为明显,其次是表皮葡萄球菌、阴沟肠杆菌和短小芽孢杆菌。决定琼脂培养基表面水分水平的平板属性和人员采用的涂布方法是另外两个主要影响因素。使用新鲜的 15/20 ml 平板在较短的时间(<60 s)进行接种,由于接种物粘附在涂布器上,无论玻璃或聚丙烯制成,都会导致 3-12%的 CFU 损失。另一方面,延长接种时间会显著降低 CFU。在琼脂表面上的自由水分耗尽后,即当平滑涂布器的运动变得有些摩擦时,涂布器在琼脂表面上的运动对营养细胞有害,而芽孢杆菌孢子受影响较小。

结论

该研究表明,SP 的进行方式对 CFU 有显著影响,这些影响受到平板条件的影响。在干燥的琼脂表面上长时间使用涂布器可能对细菌细胞有极大的危害。建议采用轻度使用涂布器的方法,该方法可计入粘附在涂布器上的接种物,或采用不涉及涂布器的 SS 方法,以尽量减少 CFU 的不一致性并最大限度地提高活菌计数。

意义和影响

本研究揭示了涂布器对细菌细胞和 CFU 的影响,并建议采用 SS 替代方法,以尽量减少 CFU 不一致性并最大程度地提高活菌计数。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验