University of New South Wales, Sydney, Australia.
Biomacromolecules. 2012 Oct 8;13(10):3418-26. doi: 10.1021/bm301351e. Epub 2012 Sep 19.
The aim of this work is to generate polymer micelles decorated with a synthetic version of cell-penetrating peptides, which are often rich in arginine with its positively charged guanidine group. A methacrylate-based monomer with guanidinium as functional groups was prepared using arginine (M-Arg) as a building block, resulting in a zwitterionic monomer. RAFT (reversible addition-fragmentation chain transfer) polymerization was employed to generate triblock copolymers with poly(methyl methacrylate)-block-poly(polyethylene glycol methyl ether methacrylate) as the first two blocks, which were subsequently chain extended with the guanidine-based monomer to generate micelles with guanidinium functional groups on the surface. To simulate the actual oligoarginine peptide, which only carries cationic charges, the carboxylate group of P(M-Arg) was methylated to convert the zwitterionic polymer into a cationic polymer P(Me-M-Arg). For comparison, micelles based on triblock copolymers with a third block with permanently cationic charges, poly(2-methacryolyloxy ethyl) trimethyl ammonium chloride (PTMA), was prepared. The hydrodynamic diameters of the micelles were approximately 30-40 nm based on DLS and TEM. A direct correlation between surface charge (zeta potential ζ) and cytotoxicity was observed. The micelles based on the zwitterionic P(M-Arg) were nontoxic (ζ = -10 mV at pH = 7), while the methylated version P(Me-M-Arg) with a high cationic charge (ζ = +35 mV at pH = 7) were observed to be toxic. The cellular uptake of the block copolymers by OVCAR-3 ovarian cancer cell lines was found to be relatively fast (about 35% in 3 min) reaching an equilibrium after approximately 30 min. Both micelles, with either P(M-Arg) or P(Me-M-Arg) on the surface, showed an enhanced uptake compared to micelles with P(PEGMEMA) as shell only. In fact, the percentage of uptake was similar, with the difference that cells incubated with micelles with P(M-Arg) (zwitterionic) stayed alive, while P(Me-M-Arg) (cationic) led to significant cell death.
这项工作的目的是生成带有合成细胞穿透肽的聚合物胶束,这些肽通常富含精氨酸及其带正电荷的胍基。使用精氨酸(M-Arg)作为构建块制备了带有胍基作为官能团的甲基丙烯酸盐单体,得到了两性离子单体。使用 RAFT(可逆加成-断裂链转移)聚合生成了三嵌段共聚物,前两个嵌段为聚(甲基丙烯酸甲酯)-嵌段-聚(聚乙二醇甲基醚甲基丙烯酸酯),随后用胍基单体进行链延伸,在表面生成带有胍基官能团的胶束。为了模拟实际的寡精氨酸肽,它只带有正电荷,将 P(M-Arg)的羧基甲基化,将两性离子聚合物转化为带正电荷的聚合物 P(Me-M-Arg)。为了比较,还制备了基于带有第三个带永久正电荷的嵌段的三嵌段共聚物的胶束,即聚(2-甲基丙烯酰氧基乙基)三甲基氯化铵(PTMA)。基于 DLS 和 TEM,胶束的水动力学直径约为 30-40nm。观察到表面电荷(zeta 电位 ζ)和细胞毒性之间存在直接相关性。基于两性离子 P(M-Arg)的胶束没有毒性(在 pH = 7 时 ζ = -10mV),而带有高正电荷(在 pH = 7 时 ζ = +35mV)的甲基化版本 P(Me-M-Arg)则表现出毒性。发现 OVCAR-3 卵巢癌细胞系对嵌段共聚物的细胞摄取相对较快(3 分钟内约 35%),大约 30 分钟后达到平衡。带有 P(M-Arg)或 P(Me-M-Arg)表面的胶束的摄取均高于仅带有 P(PEGMEMA)壳的胶束。事实上,摄取的百分比相似,只是用带有 P(M-Arg)(两性离子)的胶束孵育的细胞保持存活,而用 P(Me-M-Arg)(阳离子)的胶束则导致显著的细胞死亡。