Price P A
J Biol Chem. 1975 Mar 25;250(6):1981-6.
DNase requires Ca2+ for activity against DNA with Mg2+. The Ca2+ selective chelating agent, ethylene glycol bis(beta-aminoethyl ether)-N, N'-tetraacetic acid, (EGTA) inhibits DNase completely at pH 7 or 8, and subsequent addition of excess Ca2+ reverses inhibition in less than one second. DNase action can be stopped at any point by the addition of excess EGTA over Ca2+. Ca2+ is required for DNase to bind substrate. Gel filtration experiments fail to show DNase binding to 0.2 mg per ml of DNA at 5 mm Mg2+ and 10-4 M EGTA. The concentration of Ca2+ needed for half of maximum DNase activity decreases with increases DNA concentration, from 1.2 times 10-5 M Ca2+ at 2.3 times 10-5 M DNA-P to about 4 times 10-7 M Ca2+ at 2.3 DNA-P. Kinetic analysis by the titrametic assay of protons releases shows that V max is independent of Ca2+ concentration while Km increases from 7.7 times 10-5 M DNA-P at 5 times 10-4 M Ca2+ to 3.4 times 10-4 M DNA-P at 5 times 10-6 M Ca2+. Both of these results are predicted by a rate equation which is derived from the assumption that DNase must bind Ca2+ before it can bind DNA. The essential Ca2+ atom probably binds to the one of two high affinity Ca2+ binding sites on DNase which cannont bind Mg2+ or Mn2+. The only other divalent metal ions which can bind to this site, Sr2+ and Ba2+, are also the only metal ions which can substitute for Ca2+ in DNase action against DNA with Mg2+. Some DNase activity is obtained in the absence of added Ca2+ with Mg2+ at pH 6 or below and with Mn2+ or Co2+ at pH 8. These assay solutions are contaminated by 1 to 3 muM Ca2+, which may be sufficient to account for the observed activity.
脱氧核糖核酸酶(DNase)在与镁离子(Mg2+)共同作用于DNA时需要钙离子(Ca2+)来发挥活性。钙离子选择性螯合剂乙二醇双(β-氨基乙基醚)-N,N'-四乙酸(EGTA)在pH值为7或8时能完全抑制DNase的活性,随后加入过量的钙离子能在不到一秒的时间内逆转抑制作用。通过加入过量的EGTA而非钙离子,可在任何时刻终止DNase的作用。DNase与底物结合需要钙离子。在5 mM Mg2+和10-4 M EGTA条件下,凝胶过滤实验未能显示DNase与每毫升0.2毫克的DNA结合。使DNase活性达到最大值一半所需的钙离子浓度会随着DNA浓度的增加而降低,从2.3×10-5 M DNA-P时的1.2×10-5 M Ca2+降至2.3 DNA-P时的约4×10-7 M Ca2+。通过质子释放滴定法进行的动力学分析表明,最大反应速度(V max)与钙离子浓度无关,而米氏常数(Km)从5×10-4 M Ca2+时的7.7×10-5 M DNA-P增加到5×10-6 M Ca2+时的3.4×10-4 M DNA-P。这两个结果都由一个速率方程预测得出,该方程基于DNase必须先结合钙离子才能结合DNA的假设推导而来。必需的钙离子原子可能与DNase上两个高亲和力钙离子结合位点中的一个结合,该位点不能结合镁离子或锰离子。唯一能与该位点结合的其他二价金属离子锶离子(Sr2+)和钡离子(Ba2+),也是在DNase与镁离子共同作用于DNA时能替代钙离子的唯一金属离子。在pH值为6或更低时与镁离子、或在pH值为8时与锰离子或钴离子共同作用时,即使不添加钙离子也能获得一些DNase活性。这些测定溶液被1至3 μM的钙离子污染,这可能足以解释观察到的活性。