Instituto de Física de São Carlos, Universidade de São Paulo, Caixa Postal 369, 13560-970, São Carlos, SP, Brazil.
Biotechnol Biofuels. 2013 May 9;6(1):75. doi: 10.1186/1754-6834-6-75.
In recent years, the growing demand for biofuels has encouraged the search for different sources of underutilized lignocellulosic feedstocks that are available in sufficient abundance to be used for sustainable biofuel production. Much attention has been focused on biomass from grass. However, large amounts of timber residues such as eucalyptus bark are available and represent a potential source for conversion to bioethanol. In the present paper, we investigate the effects of a delignification process with increasing sodium hydroxide concentrations, preceded or not by diluted acid, on the bark of two eucalyptus clones: Eucalyptus grandis (EG) and the hybrid, E. grandis x urophylla (HGU). The enzymatic digestibility and total cellulose conversion were measured, along with the effect on the composition of the solid and the liquor fractions. Barks were also assessed using Fourier-transform infrared spectroscopy (FTIR), solid-state nuclear magnetic resonance (NMR), X-Ray diffraction, and scanning electron microscopy (SEM).
Compositional analysis revealed an increase in the cellulose content, reaching around 81% and 76% of glucose for HGU and EG, respectively, using a two-step treatment with HCl 1%, followed by 4% NaOH. Lignin removal was 84% (HGU) and 79% (EG), while the hemicellulose removal was 95% and 97% for HGU and EG, respectively. However, when we applied a one-step treatment, with 4% NaOH, higher hydrolysis efficiencies were found after 48 h for both clones, reaching almost 100% for HGU and 80% for EG, in spite of the lower lignin and hemicellulose removal. Total cellulose conversion increased from 5% and 7% to around 65% for HGU and 59% for EG. NMR and FTIR provided important insight into the lignin and hemicellulose removal and SEM studies shed light on the cell-wall unstructuring after pretreatment and lignin migration and precipitation on the fibers surface, which explain the different hydrolysis rates found for the clones.
Our results show that the single step alkaline pretreatment improves the enzymatic digestibility of Eucalyptus bark. Furthermore, the chemical and physical methods combined in this study provide a better comprehension of the pretreatment effects on cell-wall and the factors that influence enzymatic digestibility of this forest residue.
近年来,生物燃料需求的增长促使人们寻找利用未充分利用的木质纤维素饲料的不同来源,这些来源的丰富程度足以用于可持续的生物燃料生产。人们对草类生物质给予了大量关注。然而,桉树树皮等大量木材废料可用,并且是转化为生物乙醇的潜在来源。在本文中,我们研究了用氢氧化钠浓度递增进行脱木质素处理,以及用或不用稀酸预处理对两个桉树无性系(大花序桉(EG)和杂交桉,大花序桉×尾叶桉(HGU))树皮的影响。测量了酶解消化率和总纤维素转化率,以及对固形物和液体部分组成的影响。还使用傅里叶变换红外光谱(FTIR)、固态核磁共振(NMR)、X 射线衍射和扫描电子显微镜(SEM)对树皮进行了评估。
组成分析显示,在用 HCl 1%进行两步处理,然后用 4% NaOH 处理后,HGU 和 EG 的纤维素含量分别达到约 81%和 76%葡萄糖,达到 84%(HGU)和 79%(EG)的木质素去除率,而半纤维素去除率分别为 95%和 97%。然而,当我们应用一步处理,用 4% NaOH 处理时,在 48 小时后,两个无性系的水解效率都更高,HGU 达到近 100%,EG 达到 80%,尽管木质素和半纤维素去除率较低。总纤维素转化率从 5%和 7%增加到 HGU 的 65%和 EG 的 59%。NMR 和 FTIR 为木质素和半纤维素的去除提供了重要的见解,SEM 研究揭示了预处理后细胞壁的解构以及木质素在纤维表面上的迁移和沉淀,这解释了两个无性系之间发现的不同水解速率。
我们的结果表明,单步碱性预处理提高了桉树树皮的酶解消化率。此外,本研究中结合的化学和物理方法提供了对细胞壁预处理效果的更好理解,以及影响该森林残留物酶解消化率的因素。