Ecological Engineering Laboratory, School of Architecture, Civil and Environmental Engineering (ENAC), Station 2, Ecole Polytechnique Fédérale de Lausanne (EPFL), 1015 Lausanne, Switzerland; Laboratory for Environmental Biotechnology, School of Architecture, Civil and Environmental Engineering (ENAC), Station 6, Ecole Polytechnique Fédérale de Lausanne (EPFL), 1015 Lausanne, Switzerland.
N Biotechnol. 2013 Sep 25;30(6):803-13. doi: 10.1016/j.nbt.2013.06.004. Epub 2013 Jul 3.
Many organic compounds present at low concentrations in municipal wastewater, such as various pharmaceuticals and biocides, are recalcitrant in conventional wastewater treatment plants (WWTPs). To improve their biodegradation, oxidoreductase enzymes such as laccases were tested. The goal was to find optimal conditions for the transformation of two anti-inflammatory pharmaceuticals (diclofenac (DFC) and mefenamic acid (MFA)), one biocide (triclosan (TCN)) and one plastic additive (bisphenol A (BPA)) by Trametes versicolor laccase. Experiments were conducted in spiked solutions at different pH values (from 3 to 9), enzyme concentrations (70-1400 Ul(-1)), reaction times (0-26 hours) and temperatures (10, 25 and 40°C) following a Doehlert experimental design. A semi-empirical model was developed to understand better the combined effects of the four factors and to determine optimal values. This model was able to fit well the experimental data (R(2)>0.97) and showed good predictive ability. All four factors had a significant effect on the micropollutant oxidation with the greatest influence shown by pH. Results for single compounds were different from those obtained for mixtures of micropollutants. For instance, DFC transformation occurred at much higher rates in mixtures under alkaline conditions. Optimal conditions were compound-dependent, but were found to be between pH 4.5 to 6.5 and between 25°C to more than 40°C. A laccase concentration of 730 Ul(-1) was sufficient to obtain a high removal rate (>90%) of the four individual compounds (range of times: 40 min to 5 hours), showing the potential of laccases to improve biodegradation of environmentally persistent compounds.
许多存在于城市废水中的低浓度有机化合物,如各种药物和杀生物剂,在传统的废水处理厂(WWTP)中难以生物降解。为了提高它们的生物降解性,测试了氧化还原酶如漆酶。目标是找到最佳条件,以转化两种抗炎药物(双氯芬酸(DFC)和甲芬那酸(MFA))、一种杀生物剂(三氯生(TCN))和一种塑料添加剂(双酚 A(BPA)),使用变色栓菌漆酶。实验在不同 pH 值(3 至 9)、酶浓度(70-1400 Ul(-1))、反应时间(0-26 小时)和温度(10、25 和 40°C)的条件下,采用 Doehlert 实验设计进行。开发了一个半经验模型,以更好地理解四个因素的综合影响,并确定最佳值。该模型能够很好地拟合实验数据(R(2)>0.97),并具有良好的预测能力。所有四个因素对微污染物的氧化都有显著影响,其中 pH 的影响最大。单一化合物的结果与微污染物混合物的结果不同。例如,在碱性条件下,混合物中 DFC 的转化速率要高得多。最佳条件取决于化合物,但发现 pH 值在 4.5 到 6.5 之间,温度在 25°C 到 40°C 以上。漆酶浓度为 730 Ul(-1)足以获得四种单一化合物的高去除率(时间范围:40 分钟至 5 小时),表明漆酶具有提高环境持久性化合物生物降解的潜力。