Suppr超能文献

多节段颈椎融合中相邻节段生物力学变化与融合骨移植物数量的关系:有限元研究。

Relationship between biomechanical changes at adjacent segments and number of fused bone grafts in multilevel cervical fusions: a finite element investigation.

机构信息

Division of Research, Logan University, Chesterfield, Missouri;

出版信息

J Neurosurg Spine. 2014 Jan;20(1):22-9. doi: 10.3171/2013.9.SPINE121081. Epub 2013 Nov 1.

Abstract

OBJECT

Biomechanical studies have shown that anterior cervical fusion construct stiffness and arthrodesis rates vary with different reconstruction techniques; however, the behavior of the adjacent segments in the setting of different procedures is poorly understood. This study was designed to investigate the adjacent-segment biomechanics after 3 different anterior cervical decompression and fusion techniques, including 3-level discectomy and fusion, 2-level corpectomy and fusion, and a corpectomy-discectomy hybrid technique. The authors hypothesized that biomechanical changes at the segments immediately superior and inferior to the multilevel fusion would be inversely proportional to the number of fused bone grafts and that these changes would be related to the type of fusion technique.

METHODS

A previously validated 3D finite element model of an intact C3-T1 segment was used. Three C4-7 fusion models were built from this intact model by varying the number of bone grafts used to span the decompression: a 1-graft model (2-level corpectomy), a 2-graft model (C-5 corpectomy and C6-7 discectomy), and a 3-graft model (3-level discectomy). The corpectomy and discectomy models were also previously validated and compared well with the literature findings. Range of motion, disc stresses, and posterior facet loads at the segments superior (C3-4) and inferior (C7-T1) to the fusion construct were assessed.

RESULTS

Motion, disc stresses, and posterior facet loads generally increased at both of the adjacent segments in relation to the intact model. Greater biomechanical changes were noted in the superior C3-4 segment than in the inferior C7-T1 segment. Increasing the number of bone grafts from 1 to 2 and from 2 to 3 was associated with a lower magnitude of biomechanical changes at the adjacent segments.

CONCLUSIONS

At segments adjacent to the fusion level, biomechanical changes are not limited solely to the discs, but also propagate to the posterior facets. These changes in discs and posterior facets were found to be lower for discectomy than for corpectomy, thereby supporting the current study hypothesis of inverse relationship between the adjacent-segment variations and the number of fused bone grafts. Such changes may go on to influence the likelihood of adjacent-segment degeneration accordingly. Further studies are warranted to identify the causes and true impact of these observed changes.

摘要

目的

生物力学研究表明,不同重建技术会导致颈椎前路融合结构的刚度和融合率发生变化;然而,不同手术方式下相邻节段的行为尚不清楚。本研究旨在探讨 3 种不同颈椎前路减压融合技术(3 节段椎间盘切除术和融合术、2 节段椎体切除术和融合术以及椎体切除术-椎间盘切除术杂交技术)后相邻节段的生物力学变化。作者假设,多节段融合上下相邻节段的生物力学变化与融合骨移植物的数量成反比,且这些变化与融合技术的类型有关。

方法

使用了一个先前经过验证的 C3-T1 节段完整的 3D 有限元模型。通过改变跨越减压区的骨移植物数量,从该完整模型中构建了 3 个 C4-7 融合模型:1 个移植物模型(2 节段椎体切除术)、2 个移植物模型(C5 椎体切除术和 C6-7 椎间盘切除术)和 3 个移植物模型(3 节段椎间盘切除术)。椎体切除术和椎间盘切除术模型也经过了先前的验证,并与文献研究结果吻合良好。评估了融合结构上下相邻节段(C3-4 和 C7-T1)的活动度、椎间盘应力和后关节突负荷。

结果

与完整模型相比,活动度、椎间盘应力和后关节突负荷通常在两个相邻节段均增加。在较高的 C3-4 节段,生物力学变化比在较低的 C7-T1 节段更大。从 1 个移植物增加到 2 个移植物,以及从 2 个移植物增加到 3 个移植物,相邻节段的生物力学变化幅度较小。

结论

在融合水平相邻的节段,生物力学变化不仅限于椎间盘,而且还会传播到后关节突。与椎体切除术相比,椎间盘切除术的这些椎间盘和后关节突变化较小,从而支持当前研究假设,即相邻节段变化与融合骨移植物数量之间存在反比关系。这些变化可能会相应地影响相邻节段退变的可能性。需要进一步的研究来确定这些观察到的变化的原因和真正影响。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验