Azhdarzadeh Mehdi, Olfert Jason S, Vehring Reinhard, Finlay Warren H
Department of Mechanical Engineering, University of Alberta , Edmonton, AB T6G 2G8 Canada .
J Aerosol Med Pulm Drug Deliv. 2015 Feb;28(1):30-4. doi: 10.1089/jamp.2013.1118. Epub 2014 Apr 1.
The fraction of inhaled particles depositing in the nasal extrathoracic airways determines the amount of particles delivered to the lungs of infants. Electrostatic charge on particles can affect this deposition, and for this reason, deposition of charged aerosol particles in the Alberta Idealized Infant nasal geometry is examined.
Charged aerosol particles were generated via Plateau-Rayleigh jet breakup atomization with induction charging. Nasal deposition was measured by collecting particles on a filter membrane at the inlet and outlet of the airway and measuring their mass with an ultramicrobalance. The experiments were carried out using monodisperse, uniformly charged particles with aerodynamic diameters of 3-6 μm at two flow rates of 7.5 and 15 L/min, for a charge range of 0-10,000 e per particle.
Electrostatic charge effects are largest for the lowest flow rate, smallest particle size, and highest charge level, with deposition in this case being approximately three times that for neutral particles. Higher flow rates and larger particle size result in much weaker electrostatic effects, with even the highest charge levels giving only a few percent higher deposition for the largest particle size and flow rate considered in this study. A dimensionless empirical relation based on the experimental data was developed for predicting deposition of charged particles in the idealized infant airway.
Electrostatic charge on inhaled aerosol particles has only a minor effect on deposition for large particles at higher flow rates, because in this case inertial impaction dominates deposition. However, for particles with low inertia, for example, small particles or low flow rates, large values of electrostatic charge strongly increase nasal deposition in the present infant extrathoracic airway.
沉积在鼻外气道的吸入颗粒比例决定了输送到婴儿肺部的颗粒数量。颗粒上的静电荷会影响这种沉积,因此,研究了带电气溶胶颗粒在艾伯塔理想化婴儿鼻腔几何模型中的沉积情况。
通过具有感应充电的普拉托-瑞利射流破碎雾化产生带电气溶胶颗粒。通过在气道入口和出口的滤膜上收集颗粒并用超微天平测量其质量来测量鼻腔沉积。实验使用单分散、均匀带电的颗粒进行,其空气动力学直径为3 - 6μm,流速分别为7.5和15 L/min,每个颗粒的电荷量范围为0 - 10000 e。
对于最低流速、最小颗粒尺寸和最高电荷水平,静电荷效应最大,在这种情况下沉积量约为中性颗粒的三倍。较高的流速和较大的颗粒尺寸导致静电力效应弱得多,即使在本研究中考虑的最大颗粒尺寸和流速下,最高电荷水平下的沉积量也仅高出几个百分点。基于实验数据建立了一个无量纲经验关系式,用于预测带电颗粒在理想化婴儿气道中的沉积。
对于较高流速下的大颗粒,吸入气溶胶颗粒上的静电荷对沉积的影响较小,因为在这种情况下惯性碰撞主导沉积。然而,对于低惯性颗粒,例如小颗粒或低流速,在当前婴儿鼻外气道中,大电荷量会显著增加鼻腔沉积。