Shen Yu-I, Abaci Hasan E, Krupsi Yoni, Weng Lien-Chun, Burdick Jason A, Gerecht Sharon
Department of Chemical and Biomolecular Engineering, Johns Hopkins Physical Sciences-Oncology Center and Institute for NanoBioTechnology, Johns Hopkins University, Baltimore, MD 21218.
Department of Bioengineering, University of Pennsylvania, Philadelphia, PA 19104 USA.
Biomater Sci. 2014 May 1;2(5):655-665. doi: 10.1039/C3BM60274E.
Three-dimensional (3D) tissue culture models may recapitulate aspects of the tumorigenic microenvironment , enabling the study of cancer progression . Both hypoxia and matrix stiffness are known to regulate tumor growth. Using a modular culture system employing an acrylated hyaluronic acid (AHA) hydrogel, three hydrogel matrices with distinctive degrees of viscoelasticity - soft (78±16 Pa), medium (309± 57 Pa), and stiff (596± 73 Pa) - were generated using the same concentration of adhesion ligands. Oxygen levels within the hydrogel in atmospheric (21 %), hypoxic (5 %), and severely hypoxic (1 %) conditions were assessed with a mathematical model. HT1080 fibrosarcoma cells, encapsulated within the AHA hydrogels in high densities, generated nonuniform oxygen distributions, while lower cell densities resulted in more uniform oxygen distributions in the atmospheric and hypoxic environments. When we examined how varying viscoelasticity in atmospheric and hypoxic environments affects cell cycles and the expression of and (autophagy and apoptosis genes), and (a glucose transport gene), we observed that HT1080 cells in 3D hydrogel adapted better to hypoxic conditions than those in a Petri dish, with no obvious correlation to matrix viscoelasticity, by recovering rapidly from possible autophagy/apoptotic events and alternating metabolism mechanisms. Further, we examined how HT1080 cells cultured in varying viscoelasticity and oxygen tension conditions affected endothelial sprouting and invasion. We observed that increased matrix stiffness reduced endothelial sprouting and invasion in atmospheric conditions; however, we observed increased endothelial sprouting and invasion under hypoxia at all levels of matrix stiffness with the upregulation of vascular endothelial growth factor () and angiopoeitin-1 (). Overall, HT1080 cells encapsulated in the AHA hydrogels under hypoxic stress recovered better from apoptosis and demonstrated greater angiogenic induction. Thus, we propose that oxygen tension more profoundly influences cell fate and the angiogenic potential of 3D cultured HT1080 fibrosarcoma cells than does matrix stiffness.
三维(3D)组织培养模型可以概括肿瘤发生微环境的各个方面,从而有助于研究癌症进展。已知缺氧和基质硬度均能调节肿瘤生长。使用一种采用丙烯酸化透明质酸(AHA)水凝胶的模块化培养系统,利用相同浓度的黏附配体生成了三种具有不同黏弹性程度的水凝胶基质——软质(78±16帕斯卡)、中等(309±57帕斯卡)和硬质(596±73帕斯卡)。通过数学模型评估了大气环境(21%)、低氧环境(5%)和严重低氧环境(1%)下水凝胶中的氧含量。高密度封装在AHA水凝胶中的HT1080纤维肉瘤细胞产生了不均匀的氧分布,而较低的细胞密度则在大气和低氧环境中导致更均匀的氧分布。当我们研究大气和低氧环境中不同的黏弹性如何影响细胞周期以及自噬和凋亡基因以及葡萄糖转运基因的表达时,我们观察到3D水凝胶中的HT1080细胞比培养皿中的细胞能更好地适应低氧条件,通过从可能的自噬/凋亡事件中快速恢复并改变代谢机制,这与基质黏弹性没有明显相关性。此外,我们研究了在不同黏弹性和氧张力条件下培养的HT1080细胞如何影响内皮细胞的芽生和侵袭。我们观察到在大气条件下,基质硬度增加会降低内皮细胞的芽生和侵袭;然而,我们观察到在所有基质硬度水平下的低氧环境中,随着血管内皮生长因子和血管生成素-1的上调,内皮细胞的芽生和侵袭增加。总体而言,在低氧应激下封装在AHA水凝胶中的HT1080细胞从凋亡中恢复得更好,并表现出更大的血管生成诱导作用。因此,我们提出氧张力比基质硬度更深刻地影响3D培养的HT1080纤维肉瘤细胞的细胞命运和血管生成潜力。