Suppr超能文献

马不同关节的关节软骨厚度比较。

Comparison of equine articular cartilage thickness in various joints.

作者信息

Lee Hyeon, Kirkland W Grant, Whitmore Ryan N, Theis Kelcie M, Young Hannah E, Richardson Ashton J, Jackson Robert L, Hanson R Reid

机构信息

Department of Mechanical Engineering, Auburn University , Auburn, AL , USA and.

出版信息

Connect Tissue Res. 2014 Oct-Dec;55(5-6):339-47. doi: 10.3109/03008207.2014.949698. Epub 2014 Aug 26.

Abstract

PURPOSE

Thicknesses of fresh equine articular cartilage surfaces from the fetlock, carpal and stifle joints were measured employing a needle probe test.

MATERIALS AND METHODS

Eighty-seven samples used in measurement were cultivated from fetlock, carpal and stifle joints of 12 deceased within 4 h of death. After approximately three minutes of exposure to air during dissection, all cartilage samples were preserved in a saline solution to keep the articular cartilage hydrated for testing. The thickness was measured on five different spots on the same sample. The thicknesses of the fetlock, carpus and stifle were compared.

RESULTS

The articular cartilage of the stifle was thicker than the fetlock and carpus, while the fetlock and the carpus had similar thickness values. The average thickness of the fetlock, carpal and stifle joint are 0.86, 0.87 and 2.1 mm, respectively. They were statistically compared using the Student t-test. The differences on the articular cartilage thicknesses between the fetlock and stifle, and carpus and stifle were "very highly significant" (p < 0.001). This indicates that the articular cartilage thickness of the stifle is significantly different from that of the fetlock and carpus. Four different surfaces in the fetlock and four in the carpal joint were also compared. Significant differences between each set of the four surfaces were not observed. In the carpus, the difference in thickness between the distal radius and proximal third carpal bone articular cartilage surfaces as well as the proximal radial carpal bone and distal radial carpal bone articular cartilage surfaces were statistically significant.

摘要

目的

采用针式探头测试法测量新鲜马的跗关节、腕关节和膝关节的关节软骨表面厚度。

材料与方法

从12匹死亡后4小时内的马的跗关节、腕关节和膝关节获取87个用于测量的样本。在解剖过程中暴露于空气中约三分钟后,将所有软骨样本保存在盐溶液中,以保持关节软骨湿润以便测试。在同一样本的五个不同部位测量厚度。比较跗关节、腕关节和膝关节的厚度。

结果

膝关节的关节软骨比跗关节和腕关节厚,而跗关节和腕关节的厚度值相似。跗关节、腕关节和膝关节的平均厚度分别为0.86、0.87和2.1毫米。使用学生t检验进行统计学比较。跗关节与膝关节、腕关节与膝关节之间关节软骨厚度的差异“非常显著”(p < 0.001)。这表明膝关节的关节软骨厚度与跗关节和腕关节的有显著差异。还比较了跗关节的四个不同表面和腕关节的四个不同表面。未观察到每组四个表面之间的显著差异。在腕关节中,桡骨远端与第三腕骨近端关节软骨表面以及桡侧腕骨近端与桡侧腕骨远端关节软骨表面之间的厚度差异具有统计学意义。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验