Amer Mahetab H, White Lisa J, Shakesheff Kevin M
Wolfson Centre for Stem Cells, Tissue Engineering and Modelling (STEM), School of Pharmacy, University of Nottingham, Nottingham, UK.
J Pharm Pharmacol. 2015 May;67(5):640-50. doi: 10.1111/jphp.12362. Epub 2015 Jan 26.
This study focuses on the effect of the injection administration process on a range of cell characteristics.
Effects of different ejection rates, needle sizes and cell suspension densities were assessed in terms of viability, membrane integrity, apoptosis and senescence of NIH 3T3 fibroblasts. For ratiometric measurements, a multiplex assay was used to verify cell viability, cytotoxicity and apoptosis independent of cell number. Co-delivery with alginate hydrogels and viscosity-modifying excipients was also assessed.
Ejections at 150 μl/min resulted in the highest percentage of dose being delivered as viable cells among ejection rates tested. The difference in proportions of apoptotic cells became apparent 48 h after ejection, with proportions being higher in samples ejected at slower rates. Co-delivery with alginate hydrogels demonstrated a protective action on the cell payload.
This study demonstrates the importance of careful consideration of administration protocols required for successful delivery of cell suspensions, according to their nature and cellular responses post-ejection.
本研究聚焦于注射给药过程对一系列细胞特性的影响。
从NIH 3T3成纤维细胞的活力、膜完整性、凋亡和衰老方面评估不同喷射速率、针头尺寸和细胞悬液密度的影响。对于比率测量,采用多重分析来验证细胞活力、细胞毒性和凋亡,且与细胞数量无关。还评估了与海藻酸盐水凝胶和粘度调节剂的共同给药情况。
在所测试的喷射速率中,以150μl/分钟的速率喷射时,作为活细胞递送的剂量百分比最高。喷射后48小时,凋亡细胞比例的差异变得明显,以较慢速率喷射的样品中比例更高。与海藻酸盐水凝胶共同给药对细胞负载显示出保护作用。
本研究表明,根据细胞悬液的性质和喷射后的细胞反应,仔细考虑成功递送所需的给药方案非常重要。