Klasson Niklas, Olsson Erik, Rudemo Mats, Eckerström Carl, Malmgren Helge, Wallin Anders
Institute of Psychiatry and Neurochemistry, Department of Neuroscience and physiology, The Sahlgrenska Academy, University of Gothenburg, Box 430, SE-405 30, Göteborg, Sweden.
Department of Mathematical Sciences, Chalmers University of Technology and University of Gothenburg, SE-412 96, Göteborg, Sweden.
BMC Med Imaging. 2015 Feb 18;15:5. doi: 10.1186/s12880-015-0045-4.
Manual segmentations of the whole intracranial vault in high-resolution magnetic resonance images are often regarded as very time-consuming. Therefore it is common to only segment a few linearly spaced intracranial areas to estimate the whole volume. The purpose of the present study was to evaluate how the validity of intracranial volume estimates is affected by the chosen interpolation method, orientation of the intracranial areas and the linear spacing between them.
Intracranial volumes were manually segmented on 62 participants from the Gothenburg MCI study using 1.5 T, T1-weighted magnetic resonance images. Estimates of the intracranial volumes were then derived using subsamples of linearly spaced coronal, sagittal or transversal intracranial areas from the same volumes. The subsamples of intracranial areas were interpolated into volume estimates by three different interpolation methods. The linear spacing between the intracranial areas ranged from 2 to 50 mm and the validity of the estimates was determined by comparison with the entire intracranial volumes.
A progressive decrease in intra-class correlation and an increase in percentage error could be seen with increased linear spacing between intracranial areas. With small linear spacing (≤15 mm), orientation of the intracranial areas and interpolation method had negligible effects on the validity. With larger linear spacing, the best validity was achieved using cubic spline interpolation with either coronal or sagittal intracranial areas. Even at a linear spacing of 50 mm, cubic spline interpolation on either coronal or sagittal intracranial areas had a mean absolute agreement intra-class correlation with the entire intracranial volumes above 0.97.
Cubic spline interpolation in combination with linearly spaced sagittal or coronal intracranial areas overall resulted in the most valid and robust estimates of intracranial volume. Using this method, valid ICV estimates could be obtained in less than five minutes per patient.
在高分辨率磁共振图像中对整个颅内腔进行手动分割通常被认为非常耗时。因此,通常仅分割几个线性间隔的颅内区域来估计总体积。本研究的目的是评估颅内体积估计的有效性如何受到所选插值方法、颅内区域的方向及其之间的线性间隔的影响。
使用1.5T T1加权磁共振图像,对哥德堡轻度认知障碍研究中的62名参与者的颅内体积进行手动分割。然后,使用来自相同体积的线性间隔的冠状、矢状或横向颅内区域的子样本得出颅内体积的估计值。颅内区域的子样本通过三种不同的插值方法插值为体积估计值。颅内区域之间的线性间隔范围为2至50毫米,通过与整个颅内体积进行比较来确定估计值的有效性。
随着颅内区域之间线性间隔的增加,可以看到组内相关性逐渐降低,百分比误差增加。当线性间隔较小时(≤15毫米),颅内区域的方向和插值方法对有效性的影响可忽略不计。当线性间隔较大时,使用冠状或矢状颅内区域的三次样条插值可获得最佳有效性。即使在50毫米的线性间隔下,对冠状或矢状颅内区域进行三次样条插值与整个颅内体积的组内平均绝对一致性相关性仍高于0.97。
三次样条插值结合线性间隔的矢状或冠状颅内区域总体上能得出最有效和稳健的颅内体积估计值。使用这种方法,每位患者可在不到五分钟的时间内获得有效的颅内总体积(ICV)估计值。