Department of Food Science, University of Massachusetts , Amherst, Massachusetts 01003, United States.
Department of Biochemistry, Faculty of Science, King Abdulaziz University , P.O. Box 80203, Jeddah 21589, Saudi Arabia.
J Agric Food Chem. 2015 Nov 18;63(45):10078-88. doi: 10.1021/acs.jafc.5b03824. Epub 2015 Nov 10.
This study examined the possibility of producing oil-in-water emulsions using a natural surfactant (sunflower phospholipids) and a low-energy method (spontaneous emulsification). Spontaneous emulsification was carried out by titrating an organic phase (oil and phospholipid) into an aqueous phase with continuous stirring. The influence of phospholipid composition, surfactant-to-oil ratio (SOR), initial phospholipids location, storage time, phospholipid type, and preparation method was tested. The initial droplet size depended on the nature of the phospholipid used, which was attributed to differences in phospholipid composition. Droplet size decreased with increasing SOR and was smallest when the phospholipid was fully dissolved in the organic phase rather than the aqueous phase. The droplets formed using spontaneous emulsification were relatively large (d > 10 μm), and so the emulsions were unstable to gravitational separation. At low SORs (0.1 and 0.5), emulsions produced with phospholipids had a smaller particle diameter than those produced with a synthetic surfactant (Tween 80), but at a higher SOR (1.0), this trend was reversed. High-energy methods (microfluidization and sonication) formed significantly smaller droplets (d < 10 μm) than spontaneous emulsification. The results from this study show that low-energy methods could be utilized with natural surfactants for applications for which fine droplets are not essential.
本研究考察了使用天然表面活性剂(葵花磷脂)和低能量方法(自发乳化)制备水包油乳液的可能性。自发乳化通过将有机相(油和磷脂)滴定到含有连续搅拌的水相中进行。测试了磷脂组成、表面活性剂与油的比例(SOR)、初始磷脂位置、储存时间、磷脂类型和制备方法的影响。初始液滴尺寸取决于所用磷脂的性质,这归因于磷脂组成的差异。随着 SOR 的增加,液滴尺寸减小,并且当磷脂完全溶解在有机相而不是水相时,液滴尺寸最小。使用自发乳化形成的液滴相对较大(d > 10 μm),因此乳液对重力分离不稳定。在低 SOR(0.1 和 0.5)下,用磷脂制备的乳液的粒径小于用合成表面活性剂(吐温 80)制备的乳液,但在较高的 SOR(1.0)下,这种趋势发生了逆转。高能方法(微流化和超声处理)形成的液滴明显小于自发乳化(d < 10 μm)。本研究的结果表明,低能量方法可以与天然表面活性剂一起用于不需要精细液滴的应用。