Garcia Tatiana, Zuniga Zamalloa Carlo, Jackson P Ryan, Murphy Elizabeth A, Garcia Marcelo H
U.S. Geological Survey, Illinois Water Science Center, Urbana, IL, 61801, United States of America.
Dept. of Civil and Environmental Engineering, University of Illinois at Urbana-Champaign, Urbana, IL, 61801, United States of America.
PLoS One. 2015 Dec 29;10(12):e0145775. doi: 10.1371/journal.pone.0145775. eCollection 2015.
Asian carp eggs are semi-buoyant and must remain suspended in the water to survive, supported by the turbulence of the flow, until they hatch and develop the ability to swim. Analysis of the transport and dispersal patterns of Asian carp eggs will facilitate the development and implementation of control strategies to target the early life stages. Experimenting with Asian carp eggs is complicated due to practical issues of obtaining eggs in close proximity to experimental facilities and extensive handling of eggs tends to damage them. Herein, we describe laboratory experiments using styrene beads (4.85 mm diameter) as synthetic surrogate eggs to mimic the physical properties of water-hardened silver carp eggs. The first set of experiments was completed in a rectangular vertical column filled with salt water. The salinity of the water was adjusted in an iterative fashion to obtain a close approximation of the fall velocity of the styrene beads to the mean fall velocity of silver carp water-hardened eggs. The terminal fall velocity of synthetic eggs was measured using an image processing method. The second set of experiments was performed in a temperature-controlled recirculatory flume with a sediment bed. The flume was filled with salt water, and synthetic eggs were allowed to drift under different flow conditions. Drifting behavior, suspension conditions, and settling characteristics of synthetic eggs were observed. At high velocities, eggs were suspended and distributed through the water column. Eggs that touched the sediment bed were re-entrained by the flow. Eggs saltated when they touched the bed, especially at moderate velocities and with a relatively flat bed. At lower velocities, some settling of the eggs was observed. With lower velocities and a flat bed, eggs were trapped near the walls of the flume. When bedforms were present, eggs were trapped in the lee of the bedforms in addition to being trapped near the flume walls. Results of this research study provide insights about transport, suspension, and dispersion of silver carp eggs. The knowledge gained from this study is useful to characterize the critical hydrodynamic conditions of the flow at which surrogates for silver carp water-hardened eggs settle out of suspension, and provides insight into how eggs may interact with riverbed sediments and morphology.
亚洲鲤鱼卵具有半浮力,必须悬浮在水中才能存活,依靠水流的湍流支撑,直至孵化并发育出游泳能力。分析亚洲鲤鱼卵的运输和扩散模式将有助于制定和实施针对其早期生命阶段的控制策略。由于在实验设施附近获取鱼卵存在实际问题,且对鱼卵的大量处理往往会对其造成损害,因此对亚洲鲤鱼卵进行实验很复杂。在此,我们描述了使用直径4.85毫米的苯乙烯珠作为合成替代卵来模拟水硬化白鲢鱼卵物理特性的实验室实验。第一组实验在装满盐水的矩形垂直柱中完成。以迭代方式调整水的盐度,以使苯乙烯珠的沉降速度接近水硬化白鲢鱼卵的平均沉降速度。使用图像处理方法测量合成卵的终端沉降速度。第二组实验在带有沉积床的温控循环水槽中进行。水槽中装满盐水,让合成卵在不同水流条件下漂移。观察合成卵的漂移行为、悬浮条件和沉降特性。在高速时,卵悬浮并分布在水柱中。接触沉积床的卵会被水流重新夹带。卵接触床面时会发生跳跃,特别是在中等速度和相对平坦的床面条件下。在较低速度下,观察到一些卵沉降。在较低速度和平坦床面条件下,卵被困在水槽壁附近。当存在床形时,卵除了被困在水槽壁附近外,还被困在床形的背风处。这项研究的结果提供了有关白鲢鱼卵运输、悬浮和扩散的见解。从这项研究中获得的知识有助于确定水硬化白鲢鱼卵替代物从悬浮状态沉降出来时水流的关键水动力条件,并深入了解鱼卵可能如何与河床沉积物和形态相互作用。