Gillis Christopher C, Kaszuba Megan C, Traynelis Vincent C
Division of Neurosurgery, University of Nebraska Medical Center, Omaha, Nebraska.
Rush Medical College, Chicago; and.
J Neurosurg Spine. 2016 Oct;25(4):421-429. doi: 10.3171/2016.2.SPINE151056. Epub 2016 May 6.
OBJECTIVE Anterior cervical discectomy and fusion (ACDF) is one of the most commonly performed spine procedures. It can be used to correct cervical kyphotic deformity, which is the most common cervical deformity, and is often performed using lordotic interbody devices. Worsening of the cervical sagittal parameters is associated with decreased health-related quality of life. The study hypothesis is that through the use of machined lordotic allografts in ACDF, segmental and overall cervical lordosis can be maintained or increased, which will have a positive impact on overall cervical sagittal alignment. METHODS Seventy-four cases of 1-level ACDF (ACDF1) and 2-level ACDF (ACDF2) (40 ACDF1 and 34 ACDF2 procedures) were retrospectively reviewed. Upright neutral lateral radiographs were assessed preoperatively and at 6 weeks and 1 year postoperatively. The measured radiographic parameters included focal lordosis, disc height, C2-7 lordosis, C1-7 lordosis, T-1 slope, and C2-7 sagittal vertical axis. Correlation coefficients were calculated to determine the relationships between these radiographic measurements. RESULTS The mean values were as follows: preoperative focal lordosis was 0.574°, disc height was 4.48 mm, C2-7 lordosis was 9.66°, C1-7 lordosis was 42.5°, cervical sagittal vertebral axis (SVA) was 26.9 mm, and the T-1 slope was 33.2°. Cervical segmental lordosis significantly increased by 6.31° at 6 weeks and 6.45° at 1 year. C2-7 lordosis significantly improved by 1 year with a mean improvement of 3.46°. There was a significant positive correlation between the improvement in segmental lordosis and overall cervical lordosis. Overall cervical lordosis was significantly negatively correlated with cervical SVA. Improved segmental lordosis was not correlated with cervical SVA in ACDF1 patients but was significantly negatively correlated in ACDF2 patients. There was also a significant positive correlation between the T-1 slope and cervical SVA. CONCLUSIONS In the study population, the improvement of focal lordosis was significantly correlated with an improvement in overall lordosis (C1-7 and C2-7), and overall lordosis as measured by the C2-7 Cobb angle was significantly negatively correlated with cervical SVA. Using lordotic cervical allografts, we successfully created and maintained significant improvement in cervical segmental lordosis at the 6-week and 1-year time points with values of 6.31° and 6.45°, respectively. ACDF is able to achieve statistically significant improvement in C2-7 cervical lordosis by the 1-year followup, with a mean improvement of 3.46°. Increasing the number of levels operated on resulted in improved cervical sagittal parameters. This establishes a baseline for further examination into the ability of multilevel ACDF to achieve cervical deformity correction through the intervertebral correction of lordosis.
目的 颈椎前路椎间盘切除融合术(ACDF)是最常开展的脊柱手术之一。它可用于矫正颈椎后凸畸形,这是最常见的颈椎畸形,且常使用前凸椎间融合器进行手术。颈椎矢状面参数的恶化与健康相关生活质量下降有关。本研究假设是,在ACDF中使用加工的前凸同种异体骨移植,可维持或增加节段性和整体颈椎前凸,这将对整体颈椎矢状面排列产生积极影响。方法 回顾性分析74例单节段ACDF(ACDF1)和双节段ACDF(ACDF2)病例(40例ACDF1手术和34例ACDF2手术)。术前以及术后6周和1年评估站立位中立位侧位X线片。测量的影像学参数包括局部前凸、椎间盘高度、C2-7前凸、C1-7前凸、T-1斜率和C2-7矢状垂直轴。计算相关系数以确定这些影像学测量值之间的关系。结果 平均值如下:术前局部前凸为0.574°,椎间盘高度为4.48 mm,C2-7前凸为9.66°,C1-7前凸为42.5°,颈椎矢状椎体轴(SVA)为26.9 mm,T-1斜率为33.2°。颈椎节段性前凸在术后6周显著增加6.31°,在1年时增加6.45°。C2-7前凸在1年时显著改善,平均改善3.46°。节段性前凸的改善与整体颈椎前凸之间存在显著正相关。整体颈椎前凸与颈椎SVA显著负相关。在ACDF1患者中,节段性前凸的改善与颈椎SVA无相关性,但在ACDF2患者中显著负相关。T-1斜率与颈椎SVA之间也存在显著正相关。结论 在本研究人群中,局部前凸的改善与整体前凸(C1-7和C2-7)的改善显著相关,且通过C2-7 Cobb角测量的整体前凸与颈椎SVA显著负相关。使用颈椎前凸同种异体骨移植,我们在术后6周和1年时间点分别成功实现并维持了颈椎节段性前凸的显著改善,改善值分别为6.31°和6.45°。通过1年随访,ACDF在C2-7颈椎前凸方面能够实现统计学上的显著改善,平均改善3.46°。手术节段数增加导致颈椎矢状面参数改善。这为进一步研究多节段ACDF通过椎间前凸矫正实现颈椎畸形矫正的能力奠定了基础。