Suppr超能文献

磷脂囊泡中氯离子转运机制的定量荧光测量

Quantitative fluorescence measurement of chloride transport mechanisms in phospholipid vesicles.

作者信息

Verkman A S, Takla R, Sefton B, Basbaum C, Widdicombe J H

机构信息

Cardiovascular Research Institute, University of California, San Francisco 94143.

出版信息

Biochemistry. 1989 May 16;28(10):4240-4. doi: 10.1021/bi00436a018.

Abstract

A quantitative fluorescence assay has been developed to measure Cl flux across liposomal membranes for use in chloride transporter reconstitution studies. A Cl-sensitive fluorophore [6-methoxy-N-(3-sulfopropyl)quinolinium; SPQ] was entrapped into phospholipid/cholesterol liposomes formed by bath sonication, high-pressure extrusion, and detergent dialysis. Liposomes containing entrapped SPQ were separated from external SPQ by passage down a Sephadex G25 column. There was less than 10% leakage of SPQ from liposomes in 8 h at 4 degrees C and in 2 h at 23 degrees C. Cl influx (JCl in millimolar per second or nanomoles per second per centimeter squared) was determined from the time course of SPQ fluorescence, measured by cuvette or stopped-flow fluorometry, in response to inward Cl gradients. In 90% phosphatidylcholine (10% cholesterol liposomes at 23 degrees C, JCl in response to a 50 mM inward Cl gradient was 0.06 +/- 0.01 mM.s-1 (SD, n = 3) in the absence and 0.27 +/- 0.02 mM.s-1 in the presence of a K/valinomycin voltage clamp (0 mV), showing that the basal Cl "leak" is conductive; JCl increased (1.7 +/- 0.1)-fold in the presence of a 60-mV inside-positive diffusion potential. Accuracy of chloride influx rates determined by the SPQ method was confirmed by measurement of 36Cl uptake. In liposomes voltage-clamped to 0 mV, JCl was linear with external [Cl] (0-100 mM), independent of pH gradients, and strongly dependent on temperature (activation energy 18 +/- 1 kcal/mol, 12-42 degrees C) as predicted for channel-independent Cl diffusion.(ABSTRACT TRUNCATED AT 250 WORDS)

摘要

已开发出一种定量荧光测定法,用于测量跨脂质体膜的氯离子通量,以用于氯离子转运体重构研究。一种对氯离子敏感的荧光团[6-甲氧基-N-(3-磺丙基)喹啉鎓;SPQ]被包裹在通过浴式超声、高压挤压和去污剂透析形成的磷脂/胆固醇脂质体中。通过Sephadex G25柱将含有包裹SPQ的脂质体与外部SPQ分离。在4℃下8小时和23℃下2小时内,SPQ从脂质体中的泄漏率低于10%。氯离子内流(JCl,以毫摩尔每秒或每平方厘米每秒纳摩尔为单位)根据SPQ荧光的时间进程来确定,通过比色皿或停流荧光法测量,以响应内向氯离子梯度。在23℃下的90%磷脂酰胆碱(10%胆固醇)脂质体中,在不存在钾/缬氨霉素电压钳(0 mV)的情况下,响应50 mM内向氯离子梯度的JCl为0.06±0.01 mM·s-1(标准差,n = 3),在存在钾/缬氨霉素电压钳时为0.27±0.02 mM·s-1,表明基础氯离子“泄漏”是有传导性的;在存在60 mV内正扩散电位时,JCl增加了(1.7±0.1)倍。通过测量36Cl摄取证实了用SPQ方法测定的氯离子内流速率的准确性。在电压钳制到0 mV的脂质体中,JCl与外部[Cl](0 - 100 mM)呈线性关系,与pH梯度无关,并且如通道非依赖性氯离子扩散所预测的那样,强烈依赖于温度(活化能18±1千卡/摩尔,12 - 42℃)。(摘要截短于250字)

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验