Onesti G, González-Domínguez E, Rossi V
Department of Sustainable Crop Production, Università Cattolica del Sacro Cuore, Via E. Parmense 84, Piacenza, I-29122, Italy.
Phytopathology. 2017 Feb;107(2):173-183. doi: 10.1094/PHYTO-07-16-0255-R. Epub 2016 Nov 22.
Black rot, caused by the fungus Guignardia bidwellii, is a polycyclic disease affecting grape leaves and berries. In environmentally controlled experiments and in a 3-year field study, the effects of temperature and relative humidity (RH) were assessed on the following growth parameters of G. bidwellii: (i) formation of pycnidia and cirri in grape leaf lesions, (ii) production and germination of conidia, and (iii) length of the period between lesion appearance and pycnidia production. Pycnidia were produced between 5 and 35°C and at 90 to 100% RH but more pycnidia were produced between 20 and 30°C. No pycnidia were produced at RH < 90%. The first pycnidia were produced in approximately 2 days after lesion appearance at ≥20°C and in 8 days at 5°C; pycnidia continued to be produced on the same lesion for 5 to 16 days after lesion appearance, depending on the temperature. Models were developed to describe the effect of temperature and RH on pycnidia production, accounting for 95 and 97% of variability, respectively. Cirri were extruded only between 15 and 35°C and mainly at 100% RH. Field experiments confirmed that pycnidia are produced for several days on a leaf lesion and that the length of the period between lesion appearance and pycnidia production depends on temperature. Overall, the findings showed that production of conidia requires high humidity; under field conditions, some hours at high humidity, which usually occur at nighttime, rather than constant high humidity may be sufficient.
由葡萄球座菌(Guignardia bidwellii)引起的黑腐病是一种影响葡萄叶片和果实的多循环病害。在环境控制实验和为期3年的田间研究中,评估了温度和相对湿度(RH)对葡萄球座菌以下生长参数的影响:(i)葡萄叶片病斑上分生孢子器和卷须的形成,(ii)分生孢子的产生和萌发,以及(iii)病斑出现到分生孢子器产生之间的时间长度。分生孢子器在5至35°C以及90%至100%的相对湿度下产生,但在20至30°C之间产生的分生孢子器更多。相对湿度低于90%时不产生分生孢子器。在≥20°C时,病斑出现后约2天产生第一批分生孢子器,在5°C时则为8天;病斑出现后,分生孢子器在同一病斑上持续产生5至16天,具体取决于温度。建立了模型来描述温度和相对湿度对分生孢子器产生的影响,分别解释了95%和97%的变异性。卷须仅在15至35°C之间且主要在100%相对湿度下挤出。田间实验证实,分生孢子器在叶片病斑上会产生数天,病斑出现到分生孢子器产生之间的时间长度取决于温度。总体而言,研究结果表明分生孢子的产生需要高湿度;在田间条件下,夜间通常出现的几个小时高湿度,而非持续的高湿度可能就足够了。