Bioengineering Research Group, School of Materials, The University of Manchester, Oxford Road, Manchester, M13 9PL UK.
Wrightington Hospital, Wigan and Leigh NHS Foundation Trust, Lancashire, UK.
J Foot Ankle Res. 2017 Mar 11;10:13. doi: 10.1186/s13047-017-0194-5. eCollection 2017.
The positioning of the fracture fragment of a posterior malleolus fracture is critical to healing and a successful outcome as malunion of a posterior malleolar fracture, a condition seen in clinical practice, can affect the dynamics of the ankle joint, cause posterolateral rotational subluxation of the talus and ultimately lead to destruction of the joint. Current consensus is to employ anatomic reduction with internal fixation when the fragment size is larger than 25 to 33% of the tibial plafond.
A 3-dimensional finite element (FE) model of ankle was developed in order to investigate the effect of fragment size (6-15 mm) and offset (1-4 mm) of a malunited posterior malleolus on tibiotalar joint contact area, pressure, motion of joint and ligament forces. Three positions of the joint were simulated; neutral position, 20° dorsiflexion and 30° plantarflexion.
Compared to the intact joint our model predicted that contact area was greater in all malunion scenarios considered. In general, the joint contact area was affected more by section length than section offset. In addition fibula contact area played a role in all the malunion cases.
We found no evidence to support the current consensus of fixing posterior malleolus fractures of greater than 25% of the tibial plafond. Our model predicted joint instability only with the highest level of fracture in a loaded limb at an extreme position of dorsiflexion. No increase of peak contact pressure as a result of malunion was predicted but contact pattern was modified. The results of our study support the view that in cases of posterior malleolar fracture, posttraumatic osteoarthritis occurs as a result of load on areas of cartilage not used to loading rather than an increase in contact pressure. Ankle repositioning resulted in increased force in two ankle ligaments. Our finding could explain commonly reported clinical observations.
后踝骨折块的定位对于愈合和获得成功的结果至关重要,因为后踝骨折的愈合不良(在临床实践中可见到的一种情况)会影响踝关节的动力,导致距骨后外侧旋转半脱位,最终导致关节破坏。目前的共识是,当骨折块大小大于胫骨平台的 25%至 33%时,采用解剖复位和内固定。
为了研究愈合不良的后踝骨折块大小(6-15 毫米)和偏移(1-4 毫米)对距骨胫关节接触面积、压力、关节运动和韧带力的影响,我们开发了一个踝关节的三维有限元(FE)模型。模拟了三个关节位置:中立位、20°背屈和 30°跖屈。
与完整关节相比,我们的模型预测在所有考虑的愈合不良情况下,接触面积都更大。一般来说,关节接触面积受节段长度的影响大于节段偏移。此外,在所有愈合不良的情况下,腓骨接触面积都起作用。
我们没有证据支持目前的共识,即固定胫骨平台大于 25%的后踝骨折。我们的模型仅预测在负重肢体处于极度背屈位置的最高骨折水平时会出现关节不稳定。没有预测到愈合不良会导致峰值接触压力增加,但接触模式发生了改变。我们的研究结果支持这样一种观点,即在后踝骨折的情况下,创伤后骨关节炎的发生是由于软骨未承受负荷的区域承受负荷,而不是由于接触压力增加。踝关节复位会导致两条踝关节韧带的受力增加。我们的发现可以解释临床上常见的观察结果。