Shamloo Amir, Nejad Milad Azimi, Saeedi Milad
Department of Mechanical Engineering, Sharif University of Technology, Tehran, Iran.
Department of Mechanical Engineering, Sharif University of Technology, Tehran, Iran.
J Mech Behav Biomed Mater. 2017 Oct;74:72-83. doi: 10.1016/j.jmbbm.2017.05.020. Epub 2017 May 14.
In the present study, we investigate the effect of the hemodynamic factors of the blood flow on the cerebral aneurysms. To this end, a hypothetical geometry of the aneurysm in the circle of Willis, located in the bifurcation point of the anterior cerebral artery (ACA) and anterior communicating artery (ACoA) is modeled in a three-dimensional manner. Three cases are chosen in the current study: an untreated thin wall (first case), untreated thick wall (second case), and a treated aneurysm (third case). The effect of increasing the aneurysm wall thickness on the deformation and stress distribution of the walls are studied. The obtained results showed that in the second case, a reduction in the deformations of the walls was observed. It was also shown that the Von Mises stress has a 10% reduction in the untreated thick wall aneurysm compared to the untreated thin wall aneurysm. Thus, increasing the thickness of the aneurysm wall can be proposed as temporary remedial action. In the third case, an aneurysm that has been treated by endovascular coiling is investigated. The deformation and Von Mises stress in this case was decreased more than 43% and 87% compared to the first case, respectively. The wall shear stress distribution due to the fluid flow in the first and second cases showed small amounts of shear stress on the aneurysm sac. In these two cases, the oscillatory shear index was measured to have an approximate value of 0.47 in the aneurysm region, though, this value was measured to be about 0.1 for the third case. The hybrid effect of the wall shear stress and the oscillatory shear index on the relative residence time (RRT) was also studied. When this parameter reaches its maximum, the aneurysm rupture may occur. It was shown that by treating the aneurysm (the third case), RRT parameter can be decreased ~200 times relative to the first and second cases, which suggests an appropriate treatment of the aneurysm by choosing the coiling method.
在本研究中,我们调查了血流动力学因素对脑动脉瘤的影响。为此,以三维方式对位于大脑前动脉(ACA)和前交通动脉(ACoA)分叉点的Willis环中动脉瘤的假设几何形状进行建模。本研究选取了三种情况:未治疗的薄壁(第一种情况)、未治疗的厚壁(第二种情况)和已治疗的动脉瘤(第三种情况)。研究了增加动脉瘤壁厚度对壁变形和应力分布的影响。所得结果表明,在第二种情况下,观察到壁变形有所减少。还表明,与未治疗的薄壁动脉瘤相比,未治疗的厚壁动脉瘤的Von Mises应力降低了10%。因此,增加动脉瘤壁厚度可作为一种临时补救措施。在第三种情况下,研究了通过血管内栓塞治疗的动脉瘤。与第一种情况相比,这种情况下的变形和Von Mises应力分别降低了43%以上和87%以上。第一种和第二种情况下由于流体流动引起的壁面剪应力分布显示,动脉瘤囊上的剪应力较小。在这两种情况下,测量到动脉瘤区域的振荡剪切指数近似值为0.47,不过,第三种情况下该值约为0.1左右。还研究了壁面剪应力和振荡剪切指数对相对停留时间(RRT)的综合影响。当该参数达到最大值时,可能会发生动脉瘤破裂。结果表明,通过治疗动脉瘤(第三种情况),RRT参数相对于第一种和第二种情况可降低约200倍,这表明通过选择栓塞方法对动脉瘤进行适当治疗。