School of Chemistry, University of Bristol, Cantock's Close, Bristol BS8 1TS, United Kingdom.
School of Chemistry, University of Bristol, Cantock's Close, Bristol BS8 1TS, United Kingdom.
J Colloid Interface Sci. 2017 Nov 1;505:139-147. doi: 10.1016/j.jcis.2017.05.062. Epub 2017 May 24.
The formation of water-in-water emulsions from the aqueous two phase system containing polyethylene oxide and pullulan, stabilised by montmorillonite platelets, was investigated. A novel approach of preparing the emulsions at non-equilibrium polymer concentrations was successfully utilised to control viscosity during mixing and allow the use of low energy emulsification methods. Polyethylene oxide adsorbed to the platelets much more strongly than pullulan favouring the formation of pullulan-in-polyethylene oxide emulsions which remained stable for a period of weeks. Polarising microscopy and small angle light scattering were used to show that droplets were most likely stabilised against coalescence by the adsorption of randomly oriented aggregates of platelets and against creaming by the formation of chains of droplets bridged by the adsorbed aggregates. Montmorillonite platelets were therefore shown to stabilise water-in-water emulsions and their preference for emulsion type was driven by the adsorption of the polymers to the particle surface.
研究了由含有聚氧化乙烯和普鲁兰的双水相体系形成的水包水乳液,该体系由蒙脱土片层稳定。成功地利用了一种新颖的方法在非平衡聚合物浓度下制备乳液,以在混合过程中控制粘度并允许使用低能量乳化方法。聚氧化乙烯比普鲁兰更强烈地吸附到片层上,有利于形成聚乙烯氧化物-普鲁兰乳液,这种乳液在数周内保持稳定。偏光显微镜和小角光散射用于表明,通过吸附无规取向的片层聚集体来稳定液滴以防止聚结,并通过由吸附的聚集体桥接的液滴链来防止浮油,从而使液滴稳定。因此,蒙脱土片层被证明可以稳定水包水乳液,其对乳液类型的偏好是由聚合物在颗粒表面的吸附所驱动的。