Çavuşoğlu Ali Turgay, Erbay Fatma Kübra, Özsoy Mehmet Hakan, Demir Teyfik
1 Department of Orthopedics, Faculty of Medicine, Gazi University, Ankara, Turkey.
2 Department of Micro and Nanotechnology, TOBB University of Economics and Technology, Ankara, Turkey.
Proc Inst Mech Eng H. 2017 Oct;231(10):931-937. doi: 10.1177/0954411917718223. Epub 2017 Jul 8.
Unstable pelvic ring injuries are complex and risky injuries due to high morbidity and mortality. Although anterior pelvic external fixator is a suitable method for rapid stabilization of an injured pelvic ring, due to some disadvantages such as high complication rate, nerve damage, and difficulties of patient's mobility and comfort, there has recently been increased searching for alternative methods for stabilization of the pelvic ring. Pubic symphysis zone freely moves in pelvic models. This study aims to evaluate the biomechanical stability of anterior pelvic bridge plating and compare it with supraacetabular external fixators in an untreated unstable pelvic fracture model. Samples were loaded statically with 2-mm/min loading rate in single leg standing position. Maximum load was 2.3 kN. When loading the samples, photographs were taken continuously. Stiffness values were calculated from the load displacement curves. Some reference parameters were described and were measured from unloaded and 2.3-kN-loaded photographs of the test. The mean stiffness values were 491.14 ± 52.22, 478.55 ± 41.44, and 470.25 ± 44.51 N/mm for anterior pelvic bridge plating group, supraacetabular external fixator group, and Control group, respectively. According to the measured parameters from photographs, the mean displacement at the pubic symphysis was 4.7 ± 0.32, 15.8 ± 2.01, and 18.2 ± 0.47 mm for anterior pelvic bridge plating, supraacetabular external fixator, and Control group, respectively. The highest displacement in the pubic symphysis was found in Control group, and minimum displacement was observed in anterior pelvic bridge plating group. When the perpendicular distance between the right and left lower end of ischium was examined, it was observed that displacement was minimum in anterior pelvic bridge plating group compared to other two groups, regarding to the high stability of pubic symphysis. In conclusion, this study revealed superiority of anterior subcutaneous plate fixation with biomechanical results.
不稳定骨盆环损伤因高发病率和死亡率而成为复杂且危险的损伤。尽管前路骨盆外固定器是快速稳定受伤骨盆环的合适方法,但由于并发症发生率高、神经损伤以及患者活动和舒适度方面的困难等一些缺点,近来一直在寻找稳定骨盆环的替代方法。耻骨联合区在骨盆模型中可自由移动。本研究旨在评估前路骨盆桥接钢板固定的生物力学稳定性,并在未治疗的不稳定骨盆骨折模型中将其与髋臼上外固定器进行比较。样本在单腿站立位以2毫米/分钟的加载速率进行静态加载。最大载荷为2.3千牛。加载样本时,持续拍照。从载荷-位移曲线计算刚度值。描述了一些参考参数,并从测试样本未加载和加载2.3千牛时的照片中进行测量。前路骨盆桥接钢板固定组、髋臼上外固定器组和对照组的平均刚度值分别为491.14±52.22、478.55±41.44和470.25±44.51牛/毫米。根据照片测量的参数,前路骨盆桥接钢板固定组、髋臼上外固定器组和对照组耻骨联合处的平均位移分别为4.7±0.32、15.8±2.01和18.2±0.47毫米。耻骨联合处位移最大的是对照组,最小位移出现在前路骨盆桥接钢板固定组。当检查坐骨左右下端之间的垂直距离时,观察到与其他两组相比,前路骨盆桥接钢板固定组的位移最小,这归因于耻骨联合的高稳定性。总之,本研究通过生物力学结果揭示了前路皮下钢板固定的优越性。