Suppr超能文献

新型超介电材料:盐溶液饱和织物

Novel Superdielectric Materials: Aqueous Salt Solution Saturated Fabric.

作者信息

Phillips Jonathan

机构信息

Energy Academic Group, Naval Postgraduate School, Monterey, CA 93943, USA.

出版信息

Materials (Basel). 2016 Nov 11;9(11):918. doi: 10.3390/ma9110918.

Abstract

The dielectric constants of nylon fabrics saturated with aqueous NaCl solutions, Fabric-Superdielectric Materials (F-SDM), were measured to be >10⁵ even at the shortest discharge times (>0.001 s) for which reliable data could be obtained using the constant current method, thus demonstrating the existence of a third class of SDM. Hence, the present results support the general theoretical SDM hypothesis, which is also supported by earlier experimental work with powder and anodized foil matrices: Any material composed of liquid containing dissolved, mobile ions, confined in an electrically insulating matrix, will have a very high dielectric constant. Five capacitors, each composed of a different number of layers of salt solution saturated nylon fabric, were studied, using a galvanostat operated in constant current mode. Capacitance, dielectric constant, energy density and power density as a function of discharge time, for discharge times from 100 s to nearly 0.001 s were recorded. The roll-off rate of the first three parameters was found to be nearly identical for all five capacitors tested. The power density increased in all cases with decreasing discharge time, but again the observed frequency response was nearly identical for all five capacitors. Operational limitations found for F-SDM are the same as those for other aqueous solution SDM, particularly a low maximum operating voltage (2.3 V), and dielectric "constants" that are a function of voltage, decreasing for voltages higher than ~0.8 V. Extrapolations of the present data set suggest F-SDM could be the key to inexpensive, high energy density (>75 J/cm³) capacitors.

摘要

用恒流法对饱和NaCl水溶液的尼龙织物(织物 - 超介电材料,F - SDM)的介电常数进行测量,结果表明,即使在最短放电时间(>0.001 s)时,其介电常数也>10⁵,而在该最短放电时间下可获得可靠数据,从而证明了第三类超介电材料的存在。因此,目前的结果支持了一般的超介电材料理论假设,早期对粉末和阳极氧化箔基质的实验工作也支持这一假设:任何由包含溶解的、可移动离子的液体组成,并被限制在电绝缘基质中的材料,都将具有非常高的介电常数。研究了五个电容器,每个电容器由不同层数的饱和盐溶液尼龙织物组成,使用恒流模式运行的恒电流计进行研究。记录了放电时间从100 s到接近0.001 s时,电容、介电常数、能量密度和功率密度随放电时间的变化情况。发现所有五个测试电容器的前三个参数的滚降率几乎相同。在所有情况下,功率密度都随着放电时间的减少而增加,但同样,所有五个电容器观察到的频率响应几乎相同。F - SDM的运行限制与其他水溶液超介电材料相同,特别是最大工作电压较低(2.3 V),并且介电“常数”是电压的函数,对于高于~0.8 V的电压会降低。对当前数据集的推断表明,F - SDM可能是廉价、高能量密度(>75 J/cm³)电容器的关键。

https://cdn.ncbi.nlm.nih.gov/pmc/blobs/2fdb/5457209/e6d818220851/materials-09-00918-g001a.jpg

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验