Department of Biomedical Engineering, University of Florida, Gainesville, FL, 32611, USA.
Dilon Technologies, Inc., Newport News, VA, 23606, USA.
Med Phys. 2017 Nov;44(11):5740-5748. doi: 10.1002/mp.12564. Epub 2017 Oct 13.
This study investigated a novel gamma camera for molecular breast tomosynthesis (MBT), which is a nuclear breast imaging method that uses limited angle tomography. The camera is equipped with a variable angle, slant-hole (VASH) collimator that allows the camera to remain close to the breast throughout the acquisition. The goal of this study was to evaluate the spatial resolution and count sensitivity of this camera and to compare contrast and contrast-to-noise ratio (CNR) with conventional planar imaging using an experimental breast phantom.
The VASH collimator mounts to a commercial gamma camera for breast imaging that uses a pixelated (3.2 mm), 15 × 20 cm NaI crystal. Spatial resolution was measured in planar images over a range of distances from the collimator (30-100 mm) and a range of slant angles (-25° to 25°) using Tc line sources. Spatial resolution was also measured in reconstructed MBT images including in the depth dimension. The images were reconstructed from data acquired over the -25° to 25° angular range using an iterative algorithm adapted to the slant-hole geometry. Sensitivity was measured over the range of slant angles using a disk source. Measured spatial resolution and sensitivity were compared to theoretical values. Contrast and CNR were measured using a breast phantom containing spherical lesions (6.2 mm and 7.8 mm diameter) and positioned over a range of depths in the phantom. The MBT and planar methods had equal scan time, and the count density in the breast phantom data was similar to that in clinical nuclear breast imaging. The MBT method used an iterative reconstruction algorithm combined with a postreconstruction Metz filter.
The measured spatial resolution in planar images agreed well with theoretical calculations over the range of distances and slant angles. The measured FWHM was 9.7 mm at 50 mm distance. In reconstructed MBT images, the spatial resolution in the depth dimension was approximately 2.2 mm greater than the other two dimensions due to the limited angle data. The measured count sensitivity agreed closely with theory over all slant angles when using a wide energy window. At 0° slant angle, measured sensitivity was 19.7 counts sec μCi with the open energy window and 11.2 counts sec μCi with a 20% wide photopeak window (126 to 154 keV). The measured CNR in the MBT images was significantly greater than in the planar images for all but the lowest CNR cases where the lesion detectability was extremely low for both MBT and planar. The 7.8 mm lesion at 37 mm depth was marginally detectable in the planar image but easily visible in the MBT image. The improved CNR with MBT was due to a large improvement in contrast, which out-weighed the increase in image noise.
The spatial resolution and count sensitivity measurements with the prototype MBT system matched theoretical calculations, and the measured CNR in breast phantom images was generally greater with the MBT system compared to conventional planar imaging. These results demonstrate the potential of the proposed MBT system to improve lesion detection in nuclear breast imaging.
本研究探讨了一种新型的用于分子乳腺断层合成(MBT)的伽马相机,这是一种使用有限角度断层的核乳腺成像方法。该相机配备了可变角度、倾斜孔(VASH)准直器,可使相机在整个采集过程中保持贴近乳房。本研究的目的是评估该相机的空间分辨率和计数灵敏度,并使用实验性乳房体模比较与传统平面成像的对比度和对比噪声比(CNR)。
VASH 准直器安装在用于乳腺成像的商业伽马相机上,该相机使用像素化(3.2 毫米)、15×20 厘米的 NaI 晶体。使用 Tc 线源在距准直器 30-100 毫米和倾斜角-25°至 25°的范围内测量平面图像中的空间分辨率。还在包括深度维度的重建 MBT 图像中测量了空间分辨率。使用适用于倾斜孔几何形状的迭代算法,从采集的-25°至 25°角度范围内的数据进行重建。使用圆盘源测量倾斜角度范围内的灵敏度。测量的空间分辨率和灵敏度与理论值进行了比较。使用包含球形病变(6.2 毫米和 7.8 毫米直径)的乳房体模并将其置于体模中的不同深度位置来测量对比度和 CNR。MBT 和平面方法具有相同的扫描时间,并且乳房体模数据中的计数密度与临床核乳腺成像相似。MBT 方法使用结合了重建后 Metz 滤波器的迭代重建算法。
在距准直器 50 毫米的范围内,测量的平面图像中的空间分辨率与理论计算非常吻合。测量的 FWHM 为 9.7 毫米。在重建的 MBT 图像中,由于角度数据有限,深度方向的空间分辨率比其他两个方向大约 2.2 毫米。当使用宽能窗时,在所有倾斜角度下,测量的灵敏度与理论值非常接近。在 0°倾斜角下,使用开能窗时测量的灵敏度为 19.7 计数 sec μCi,使用 20%宽光电峰窗(126 至 154keV)时为 11.2 计数 sec μCi。在 MBT 图像中测量的 CNR 通常大于平面图像,除了 CNR 最低的情况外,在这些情况下,MBT 和平面的病变检测率都极低。37 毫米深度的 7.8 毫米病变在平面图像中几乎无法检测到,但在 MBT 图像中很容易看到。MBT 中对比度的大幅提高导致 CNR 的提高,超过了图像噪声的增加。
原型 MBT 系统的空间分辨率和计数灵敏度测量结果与理论计算相符,并且在乳房体模图像中测量的 CNR 通常高于传统的平面成像。这些结果表明,所提出的 MBT 系统有潜力改善核乳腺成像中的病变检测。