Farhadian Nasrin, Rezaei-Soufi Loghman, Jamalian Seyed Farzad, Farhadian Maryam, Tamasoki Shahrzad, Malekshoar Milad, Javanshir Bahareh
Hamadan University of Medical Sciences, Dental Faculty, Orthodontics Department (Hamadan, Iran).
University of Medical Sciences, Dental Research Center, Department of Restorative Dentistry. Hamadan (Hamadan, Iran).
Dental Press J Orthod. 2017 Jul-Aug;22(4):53-60. doi: 10.1590/2177-6709.22.4.053-060.oar.
: Many patients seeking orthodontic treatment already have incipient enamel lesions and should be placed under preventive treatments. The aim of this in vitro study was to evaluate the effect of CPP-ACP paste and CO2 laser irradiation on demineralized enamel microhardness and shear bond strength of orthodontic brackets.
: Eighty caries-free human premolars were subjected to a demineralization challenge using Streptococcus mutans. After demineralization, the samples were randomly divided into five equal experimental groups: Group 1 (control), the brackets were bonded without any surface treatment; Group 2, the enamel surfaces were treated with CPP-ACP paste for 4 minutes before bonding; Group 3, the teeth were irradiated with CO2 laser beams at a wavelength of 10.6 µm for 20 seconds. The samples in Groups 4 and 5 were treated with CO2 laser either before or through CPP-ACP application. SEM photomicrographs of a tooth from each group were taken to observe the enamel surface. The brackets were bonded to the buccal enamel using a conventional method. Shear bond strength of brackets and ARI scores were measured. Vickers microhardness was measured on the non-bonded enamel surface. Data were analyzed with ANOVA and Tukey test at the p< 0.05 level.
: The mean shear bond strength and microhardness of the laser group were higher than those in the control group and this difference was statistically significant (p< 0.05). All groups showed a higher percentage of ARI score 4.
: CO2 laser at a wavelength of 10.6 µm significantly increased demineralized enamel microhardness and enhanced bonding to demineralized enamel.
许多寻求正畸治疗的患者已经存在早期釉质病变,应接受预防性治疗。本体外研究的目的是评估酪蛋白磷酸肽-无定形磷酸钙(CPP-ACP)糊剂和二氧化碳激光照射对脱矿釉质显微硬度及正畸托槽剪切粘结强度的影响。
选取80颗无龋的人类前磨牙,用变形链球菌进行脱矿挑战。脱矿后,将样本随机分为五个相等的实验组:第1组(对照组),托槽粘结前不进行任何表面处理;第2组,粘结前用CPP-ACP糊剂处理釉质表面4分钟;第3组,用波长为10.6μm的二氧化碳激光束照射牙齿20秒。第4组和第5组的样本在应用CPP-ACP之前或过程中用二氧化碳激光处理。拍摄每组一颗牙齿的扫描电子显微镜照片以观察釉质表面。采用传统方法将托槽粘结到颊侧釉质上。测量托槽的剪切粘结强度和粘结剂残留指数(ARI)评分。在未粘结的釉质表面测量维氏显微硬度。数据采用方差分析和Tukey检验,检验水准为p<0.05。
激光组的平均剪切粘结强度和显微硬度高于对照组,且差异具有统计学意义(p<0.05)。所有组的ARI评分为4的百分比均较高。
波长为10.6μm的二氧化碳激光显著提高了脱矿釉质的显微硬度,并增强了与脱矿釉质的粘结。