TADF Material Design: Photophysical Background and Case Studies Focusing on Cu and Ag Complexes.

The development of organic light emitting diodes (OLEDs) and the use of emitting molecules have strongly stimulated scientific research of emitting compounds. In particular, for OLEDs it is required to harvest all singlet and triplet excitons that are generated in the emission layer. This can be achieved using the so-called triplet harvesting mechanism. However, the materials to be applied are based on high-cost rare metals and therefore, it has been proposed already more than one decade ago by our group to use the effect of thermally activated delayed fluorescence (TADF) to harvest all generated excitons in the lowest excited singlet state S . In this situation, the resulting emission is an S →S fluorescence, though a delayed one. Hence, this mechanism represents the singlet harvesting mechanism. Using this effect, high-cost and strong SOC-carrying rare metals are not required. This mechanism can very effectively be realized by use of Cu or Ag complexes and even by purely organic molecules. In this investigation, we focus on photoluminescence properties and on crucial requirements for designing Cu and Ag materials that exhibit short TADF decay times at high emission quantum yields. The decay times should be as short as possible to minimize non-radiative quenching and, in particular, chemical reactions that frequently occur in the excited state. Thus, a short TADF decay time can strongly increase the material's long-term stability. Here, we study crucial parameters and analyze their impact on the TADF decay time. For example, the energy separation ΔE(S -T ) between the lowest excited singlet state S and the triplet state T should be small. Accordingly, we present detailed photophysical properties of two case-study materials designed to exhibit a large ΔE(S -T ) value of 1000 cm (120 meV) and, for comparison, a small one of 370 cm (46 meV). From these studies-extended by investigations of many other Cu TADF compounds-we can conclude that just small ΔE(S -T ) is not a sufficient requirement for short TADF decay times. High allowedness of the transition from the emitting S state to the electronic ground state S , expressed by the radiative rate k (S →S ) or the oscillator strength f(S →S ), is also very important. However, mostly small ΔE(S -T ) is related to small k (S →S ). This relation results from an experimental investigation of a large number of Cu complexes and basic quantum mechanical considerations. As a consequence, a reduction of τ(TADF) to below a few μs might be problematic. However, new materials can be designed for which this disadvantage is not prevailing. A new TADF compound, Ag(dbp)(P -nCB) (with dbp=2,9-di-n-butyl-1,10-phenanthroline and P -nCB=bis-(diphenylphosphine)-nido-carborane) seems to represent such an example. Accordingly, this material shows TADF record properties, such as short TADF decay time at high emission quantum yield. These properties are based (i) on geometry optimizations of the Ag complex for a fast radiative S →S rate and (ii) on restricting the extent of geometry reorganizations after excitation for reducing non-radiative relaxation and emission quenching. Indeed, we could design a TADF material with breakthrough properties showing τ(TADF)=1.4 μs at 100 % emission quantum yield.