Department of Materials Science and Engineering, Massachusetts Institute of Technology, Cambridge, MA 02139, USA.
Soft Matter. 2017 Nov 22;13(45):8511-8524. doi: 10.1039/c7sm00638a.
Dual-associative protein di- and triblock copolymers composed of sticker-decorated midblocks and micelle-forming elastin-like polypeptide (ELP) endblocks form shear-thinning, thermoresponsively reinforceable hydrogels that are potentially useful as injectable materials for a variety of applications. Here, the combination of rheological and in situ scattering measurements under shear on these dual-associative gels is employed in order to better understand how block architecture plays a role in controlling microscopic structural rearrangement and the resulting macroscopic mechanical responses. These gels, which form a disordered sphere phase due to endblock aggregation under quiescent conditions with the midblock domains physically crosslinked by protein associations, exhibit both viscoelastic and thixotropic signatures with relative magnitudes dependent upon gel concentration and block architecture. In situ SAXS measurements during flow indicate that these thixotropic responses correspond to the development of ordered domains following start-up of shear. For both architectures, the rate of alignment increases with increasing concentration. However, the rate of domain formation when increasing the temperature from 35 to 50 °C depends on the interplay between thermoresponsive toughening of the endblocks and softening of the coiled-coil domains such that rate of rearrangement decreases in the triblock while it increases in the diblock. Following a step-down in shear flow, structural rearrangement within the samples results in a thixotropic stress response. Upon cessation of flow, gel recovery is characterized by a concentration-dependent restoration of the micellar network over time, with two timescales observed that correspond to two different length scales of network relaxation.
由贴壁修饰的中间嵌段和胶束形成弹性蛋白样多肽(ELP)端基组成的双缔合蛋白二嵌段和三嵌段共聚物形成剪切稀化、热响应增强的水凝胶,有望用作各种应用的可注射材料。在这里,对这些双缔合凝胶在剪切下的流变和原位散射测量相结合,以更好地理解嵌段结构如何在控制微观结构重排和由此产生的宏观力学响应方面发挥作用。这些凝胶在静止条件下由于端基聚集而形成无序球相,其中中间嵌段域通过蛋白质缔合物理交联,在相对浓度和嵌段结构依赖的情况下表现出粘弹性和触变性特征。在流动过程中的原位 SAXS 测量表明,这些触变响应对应于剪切启动后有序域的发展。对于两种结构,随着浓度的增加,取向速率增加。然而,当温度从 35°C 升高到 50°C 时,端基的热响应增韧和卷曲螺旋域的软化之间的相互作用决定了嵌段共聚物中结构重排的速率降低,而三嵌段共聚物中的速率增加。在剪切流下降后,样品内的结构重排导致触变应力响应。停止流动后,凝胶恢复的特征是随着时间的推移,胶束网络的浓度依赖性恢复,观察到两个时间尺度对应于网络松弛的两个不同长度尺度。